Graco 3A2993B GLC2200 Wiring Harness Kit User's Manual

Graco Controllers User's Manual - 3A2993B GLC2200 Wiring Harness Kit.
Download
Page  of 2
4.2, 1815 votes
background image

Instructions

GLC 2200 Wiring 
Harness Kit

Used to interface the GLC 2200 Lubrication Controller to pump and pump accessories. For 
professional use only. 

Not approved for use in European explosive atmosphere locations. 

Kit Nos.: 24P314
Kit is rated IP65.

Instructions

1.

Verify the Connector end of the cable is NOT 
plugged in to the GLC2200 controller.

2.

Remove 2 to 3 inches of the outer insulation (a) from 
bare end of the cable as shown FIG. 1.

.

3.

Strip each wire (b) as shown in FIG. 2.

4.

Using the Wiring Key Table provided on the reverse 
side of these instructions, connect components to 
cable wires matching each wire color shown on the 
Table to the related component. 

Verify all negative and positive wire colors are cor-
rectly assigned.

5.

Plug connector into the GLC2200 unit matching pin 
numbers to Connector Identification Label (shown 
on the reverse side of these instructions). 

NOTE: The connector can only be plugged into the 
GLC2200 one way. The clip (c) should be facing 
down when the connector is correctly oriented.

Important Safety Instructions
Read all warnings and instructions in this 
manual and the GLC2200 Lubrication Controller 
instruction manual included with your unit. Save 
these instructions.

FIG. 1

FIG. 2

a

b

FIG. 3

c

3A2993B

EN

0.611174s