GE ZISS360NRSS User's Manual
Specification Revised 1/04
110104
ZISS360NRSS – GE Monogram 36" Stainless Steel Built-In Side-by-Side
Refrigerator with Automatic Icemaker and Water Filter
Water and Electrical Locations
The opening must be prepared with the electrical and water
supply located as shown.
The cutout depth must be 24".
The refrigerator wil project forward, slightly beyond adjacent
cabinetry, depending on your instal ation.
The cutout depth beneath a soffit:
When instal ed beneath a soffit, the soffit cannot exceed the
24" instal ation depth shown. The top case trim overlaps the
bottom of the soffit.
Frameless cabinets:
The case trim overlaps cabinets at the top and sides.
Therefore, frameless cabinets may require fil er strips to
prevent interference with cabinet door swing. The opening
must al ow for fil er strips.
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is required.
An individual properly grounded branch circuit or circuit
breaker is recommended. Instal a properly grounded
3-prong electrical receptacle recessed into the back wal .
Electrical must be located on rear wal as shown.
Note: GFI (ground fault interrupter) is not recommended.
• Water line can enter the opening through the floor or back
wal . The water line should be 1/4" O.D. copper tubing or
GE SmartConnect™ kit between the cold water line and
water connection location, long enough to extend to the
front of the refrigerator. Instal ation of an easily accessible
shut off valve in the water line is recommended.
The Installation Space
Product Clearances
These refrigerators are equipped with a 2 position door stop.
The factory set 130° door swing can be adjusted to 90° if
clearance to adjacent cabinets or wal s is restricted.
* Shipping height.
The refrigerator
can be adjusted to
fit into a cutout that
is 83-1/2” min. to
84-1/2” max. height
Note that the top
case trim at the
front is 1/2” higher
and wil overlap
upper cabinetry or
soffit. Use leveling
legs and wheels for
a maximum 1" height
adjustment.
194Dia26
15"
13"
Al ow minimum clearances for freezer door and fresh food
door for a ful 130° door swing and to al ow for pan removal.
4" minimum clearance is required when door swing is adjusted
to 90°. If the 90° door stop position is used, pan access is
maintained, but pan removal is restricted.
Installation Information: Before installing, consult
installation instructions packed with product, or available
at Monogram.com, for current dimensional data.
R
Listed by
Underwriters
Laboratories
As an ENERGY STAR®
partner, GE has determined
that this product meets the
ENERGY STAR guidelines
for energy efficiency.
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
GEAppliances.com or cal
GE Answer Center® service, 800.626.2000.
*84" From
Floor to
Top Frame
36"
Frame to Frame
35"
Case Width
*83-1/2"
at
Rear
25-3/4"
27-3/4"
including
handle
35-1/2"
6"
5"
Electrical
Area
84-1/2" max
83-1/2" min
Finished
Opening
75" From Floor
to Bottom
of Electrical
Area
24"
5"
5"
3-1/2"
Water Supply
3-1/2"
36" Models 12"
194Dia4
23-7/8"
Behind
Frame
20-5/8
4" Min.
to Wall
Related Manuals for GE ZISS360NRSS
-
Actron Barcode Reader OBD II PocketScan Code Reader CP9125 User's Manual
44 pages
-
Toshiba Barcode Reader B-EV4T SERIES Owner's Manual
7 pages
-
Toshiba Barcode Reader B-SX8T SERIES Owner's Manual
139 pages
-
Honeywell Barcode Reader Honeywell Barcode Reader 1900 EZ User's Manual
9 pages
-
Honeywell Barcode Reader NIAGARA WEB-700 User's Manual
28 pages
-
Samsung Barcode Reader SYNCMASTER 901B User's Manual
111 pages
-
Sharp Barcode Reader Sharp Barcode Reader XE-A507 User's Manual
2 pages
-
Actron Barcode Reader OBD II PocketScan Code Reader CP9125 User's Manual
46 pages
-
Actron Barcode Reader OBD II POCKETSCAN CP9125 User's Manual
44 pages
-
Mercedes Benz Barcode Reader CS1000 User's Manual
169 pages
-
Datalogic Scanning Barcode Reader GRYPHON GM4100 User's Manual
52 pages
-
Datalogic Scanning Barcode Reader MAGELLAN 1000I User's Manual
176 pages
-
Datalogic Scanning Barcode Reader POWERSCAN D8330 User's Manual
212 pages
-
Datalogic Scanning Barcode Reader POWERSCAN M8300 User's Manual
212 pages
-
Datalogic Scanning Barcode Reader QUICKSCAN QD2100 User's Manual
320 pages
-
Datalogic Scanning Barcode Reader QUICKSCAN QS2500 User's Manual
76 pages
-
Datalogic Scanning Barcode Reader QUICKSCAN QS6500BT User's Manual
336 pages
-
Symbol Technologies Barcode Reader MC9000-G User's Manual
484 pages
-
Unitech Barcode Reader Unitech Barcode Reader MS860 User's Manual
96 pages
-
Black Box Barcode Reader Black Box Barcode Reader TS1002A User's Manual
153 pages
-
Black Box Barcode Reader Black Box Barcode Reader TS1003A User's Manual
153 pages
-
Cino Barcode Reader FUZZYSCAN F680 User's Manual
2 pages
-
Cino Barcode Reader FUZZYSCAN F760 User's Manual
2 pages
-
Inateck Barcode Reader BCST-10 Quick Start Guide
4 pages