GE Pedestrian Signals Installation Guide

GE Transportation Installation Guide - Pedestrian Signals.
Download
Page  of 1
4.9, 1212 votes
background image

 
 

Installation Instructions 

GT1TM LED Pedestrian 16x18’’ Incandescent Look Signal Modules 

Full Hand/Person Side-by-Side & Overlay/Countdown  

 

 
 
 

 

 

Installation Steps
1.  Verify input voltage is within specified range on the back of the LED signal module before 

installation.  Failure to do so will cause lamp to fail. 

2.  Open front cover of (customer supplied) traffic signal housing. 

3.  Connect the wires to the appropriate terminal block within customer supplied signal housing. 

(Orange wire (+ for Hand), Blue Wire (+ for Person) and White wire for the neutral). 

4.  Close front cover of (customer supplied) traffic signal housing ensuring that the module gasket is 

tight within the housing. 

 

 

 

 

 

 

 

 

 

 

 

 
 

 

 

 

 

 

 

 

 

 
 

16 x 18 inch Overlay / Countdown 

16 x 18 inch Full Hand / Full Person Side-by-Side 

Back of 16 x 18 inch Pedestrian Module 

Voltage Rating 

Blue Wire 

Orange Wire 

White Wire 

Risk of Electric Shock 
Install unit in enclosure tested 

to be suitable for wet locations 

only. 

 

Prepare Electrical Wiring 

 

 

BEFORE YOU BEGIN 
Read these instructions completely and carefully. 

 

Electrical Requirements

  

  Do not use in wet locations 
  Follow all National Electric Codes 

(NEC) and local codes. 

 

GE Lighting Solutions    •    1-888-MY-GE-LED    •    www.gelightingsolutions.com 
 

1 - 8 8 8 - 6 9 - 4 3 - 5 3 3  

 

 

GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. GT1 is a trademark of GE Lighting Solutions, LLC. The GE brand and logo are trademarks of the General 

Electric Company.  © 2010 GE Lighting Solutions, LLC. Information provided is subject to change without notice. All values are design or typical values when measured under 

laboratory conditions. 

TRAF045-R120110

0.570419s