GE Incandescent Look Installation Guide

GE Transportation Installation Guide - Incandescent Look.
Download
Page  of 1
4.8, 2150 votes
background image

 
 

 

Installation Instructions 

GT1TM LED Arrow Signals 

12 inch ("Omnidirectional" Arrow)

 

 

 
 
 
 
 
 

Installation Steps: 
1.   Verify input voltage is within specified range on the back of the LED signal module before installation.  

Failure to do so will cause lamp to fail. 

 

Open front cover of (customer supplied) traffic signal housing. 

2.   Remove outer lens and incandescent bulb from traffic signal housing OR existing LED signal module.  Retain 

all hardware as removed as it may be needed in subsequent steps. 

       NOTE:  Installer is responsible for ensuring the disposal of removed components complies with all applicable 

regulatory requirements

3.   Ensure that a gasket is present around the perimeter of the new LED signal module. 
4.   Insert the LED signal module into the available cavity from previous LED module or incandescent bulb. 

   

NOTE:  Ensure that the arrow ’’’’ on the back cover of the LED signal module is oriented in the desired 
position.  

5.   Install mounting hardware to ensure that the LED signal module is securely fastened to traffic signal 

housing. 

6.   Connect the white wire to the neutral terminal block and the colored wire to the positive, supply voltage 

terminal block. 

   

NOTE:  Ensure that the correct wire is securely connected to correct terminal block for proper operation. 

7.   After installation of all modules is complete, ensure all traffic signal housings are closed and secured 

properly.  

8.   Apply power and ensure proper operation of traffic signal modules per intersection requirements as 

specified by customer. 

 

 

 

 

 

 

 
 

 

Arrow () 

“Suitable for mounting in 

any orientation” 

Voltage rating 

OD 

Risk of Electric Shock 

Install unit in enclosure tested to be 

suitable for wet locations only. 

 

Prepare Electrical Wiring 

 

 

BEFORE YOU BEGIN 
Read these instructions completely and carefully. 

 

Electrical Requirements

  

  Do not use in wet locations 
  Follow all National Electric Codes 

(NEC) and local codes. 

 

GE Lighting Solutions    •    1-888-MY-GE-LED    •    www.gelightingsolutions.com 
 

1 - 8 8 8 - 6 9 - 4 3 - 5 3 3  

 

 

GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. GT1 is a trademark of GE Lighting Solutions, LLC. The GE brand and logo are trademarks of the 

General Electric Company.  © 2010 GE Lighting Solutions, LLC. Information provided is subject to change without notice. All values are design or typical values when measured 

under laboratory conditions. 

TRAF040-R120110

 

0.584567s