GE 54335 GE 24Hour Easy Reach Timer Owner's Manual

GE Timers Owner's Manual - 54335 GE 24Hour Easy Reach Timer.
Download
Page  of 1
4.7, 1695 votes
background image

54335 
 
Easy Reach Timer 
 
INSTRUCTIONS: 
When the timer is plugged in, the timer’s dial will turn clockwise. The pointer on the face of the 
dial points to the current time of day. 
1. Locate the segments around on the outer edge of the timer’s dial. These segments, each 
representing 30 minutes, can be pushed down and away from the edge of the dial (try using 
the tip of a pen or pencil). Conversely, segments that have been pushed down can be easily 
pushed back up by hand. Be sure all segments are pushed up before programming. Select a time 
period (or periods) you want the lamp turned on, then push down ALL the segments that fall on or 
within that time period. For example, to have the timer turn a lamp on at 10PM and off at 2AM, 
push down the segments representing 10PM and 2AM, and ALL the segments in between. [See 
Figure 1.] You may need to turn the dial clockwise to access the desired segments. 
2. Rotate the timer’s dial clockwise until the pointer on the face of the dial points to the current 
time of day. Note: Nighttime hours (from 6PM to 5AM) are highlighted with a blue background. 
3. Set master switch to the TIMER ON position. 
4. Plug timer cord into an electrical outlet convenient to the lamp to be controlled. 
5. Plug the lamp into the outlet on the timer cord. Turn the lamp’s switch on for automatic control. 
The timer will not turn the lamp on if the lamp’s switch is off. The lamp will now turn on and off at 
the times you have set. 
NOTE: To override the timer and use your lamp normally, set the master switch to the 
OUTLET ON position. This will deactivate the timer’s control of the lamp, but the timer’s dial 
will still show the current time of day. To reactivate the timer’s control of the lamp, turn the lamp’s 
switch on and set the timer’s master switch to TIMER ON. In case of power failure, reset the time 
of day as explained in step 2. 
 
DO NOT PLUG IN MORE THAN THE RATED LOAD (SEE RATINGS).  
To find total watts being used: 
If watts are not marked on the appliance, multiply ampere rating 
(on nameplate) by 125 volts to determine equivalent watts. For lamps with multiple bulbs, sum 
wattage on bulbs.  
 
This is a POLARIZED device. It has a polarized plug (one blade is wider than the other) and a 
polarized outlet (one slot is longer than the other). The polarized plug is not intended to be mated 
with non-polarized outlets (where both slots are the same size). A polarized outlet is intended to 
mate with a polarized plug in only one way — the longer slot with the wider blade. 
 
 
 
Figure 1 - shows timer set to turn lights ON at 10 PM and OFF at 2 AM. Notice ALL segments 
between 10 PM and 2 AM have been pushed out. Current time is 9:00 PM. 
 

Related Manuals for GE 54335 GE 24Hour Easy Reach Timer

0.504060s