GE 45255 Digital Home Monitoring Kit Owner's Manual | Page 7

GE Monitors Owner's Manual - 45255 Digital Home Monitoring Kit.
Download
Page  of 15
4.1, 1935 votes
background image

7

To be notifi ed with the screen in standby mode...
1. Adjust/disable audio & motion sensitivity (refer to the 
    ‘Settings’ section in the manual)
2. Press and release the ‘menu’ button on the monitor. 
    Use the directional keypad to highlight ‘Alarm Volume’. 
    Press and release the ‘ok’ button.
3. Adjust the volume using the ‘left’ and ‘right’ arrows on 
    the directional keypad. Adjust to desired level. Press and
    release the ‘ok’ button to save. Press and release the ‘menu’
    button to exit.
4. In manual or scan mode, press and release the 
    ‘stdby’ button. The screen will turn off.

When motion and/or sound is detected by camera, the 
screen will automatically turn back on and will remain lit for 
approximately 15 seconds after the motion or sound stops. 
This will repeat for each detection. 

5. Press and release the ‘stdby’ button to exit.

FEATURES:
 NIGHT LIGHT

The Night Light can be activated two ways:
1. Manually - Press and release the 
    button on top of the camera to manually 
    turn on or off.
2. Remotely - Press and release the button on the right side of 
    the monitor. The night light will illuminate on the camera shown 
    on the screen.

NOTE: The night light feature is not supported in quad mode 
(multi-screen) view—only in single camera view.

 TALK-BACK

Speak directly to currently selected 
camera channel:
1. Locate the ‘talk back’ button on the 
    left side of the monitor. 
2. Press and hold the ‘talk back’ button.
3. Begin speaking. 
4. Release when fi nished. 

Adjust the volume level on the camera if needed (located below 
the sensitivity dial).

NOTE: The talk back feature is not supported in quad view.

 LULLABIES

Play musical tunes from each camera. 
Once activated, a playlist consisting of 4 
different lullabies will play and repeat until 
playback is stopped.
1. Press and release the ‘music’ button on 
    the left side of the monitor.
2. Press and release the button repeatedly to cycle through the
    lullabies stored on the camera. The name of the lullaby will 
    appear on the screen.
3. Press and release the button to exit.

NOTE: Individual lullabies cannot be played repeatedly. Importing 
custom music to replace lullabies is not supported. If lullabies 
continue to play after pressing the button, there may be a reception 
problem. Try bringing the monitor closer to the camera and try again.

 DIGITAL PAN/TILT AND ZOOM

1. Press and release the ‘menu’ button on the monitor. Using the 
    directional keypad, highlight the ‘Settings’ option. 
2. Press and release the ‘ok’ button. Using the directional keypad, 
    highlight the ‘Zoom’ option. 

 

night light

lullaby 
control
(music)

talk back 
control

0.497057s