GE 19214 GE Direct Wire Door Chime Owner's Manual

 

              Wired Chime

Installation Instructions for 
Wired Chime

Power Requirement: 16VAC @ 180mA
maximum

Included hardware:
(1) Chime
(4) Plastic screw anchors
(4) 4x25mm screws (for anchors)

Required Tools:
Wire stripper/cutter, small flat blade
screwdriver, Phillips screwdriver, drill, 
and drill bit (5/32”)

Removing Front Cover
The following instructions explain how to
remove the front cover of the wired 
chime.
1. With the cover face down hold the 
front cover while sliding the back plate 
to the left.
2. Using your finger gently pry up on the
back cover plate. The back plate with
the paper product label should come
away easily.

Chime Tune Setting
The following instructions explain how to
change the tune on the wired chime.
1. Remove the chime cover and locate the 
two 3 position dip switches shown below.

2. Select the desired chime sound from
the table below.

Chime Sound Table

Position    

1  

2  

3

Westminster  

OFF  

OFF  

ON

Ding Dong  

OFF  

ON  

OFF

Knock  

 

ON  

OFF  

OFF

Bronze Chime  

OFF  

ON  

ON

Cuckoo Clock  

ON  

OFF  

ON

Foghorn    

ON  

ON  

OFF

Gong  

 

ON  

ON  

ON

ON: Switch On (up)
OFF: Switch Off (down)

             WARNING: Do not exceed 16VAC
input to the chime.

Installation
1. Remove the cover from the old door
chime, disconnect the transformer and
pushbutton wires (label them for

reference). Remove the old chime.
2. Install new chime
a. Remove the front cover from the chime.
b. Pull the pushbutton and transformer wires through the slot in the base of chime.
c. Mark the 4 holes using the base as a template with the arrow pointing up.
d. If using the screw anchors, drill 4 - 5/32”holes and insert the plastic screw anchors. 

Otherwise drill a 3/64” pilot hole for the screws.

e. Mount the chime base using the 4x25mm screws.

f. Attach the two wires from each pushbutton as shown in the wiring diagram. For each push 

button, one wire should be connected to the “Common” screw and one wire should be 

connected to the “Front” or “Rear” screw.

g. Attach the wires from the chime transformer to the “transformer connections” as shown in 

the wiring diagram. (There is no polarity requirement).

h. Slide the front cover on the back plate of the chime.

Wiring Diagram

For technical support contact Jasco

Products Company at 1-800-654-8483

or www.jascoproducts.com

Made in China

Hecho en China

            is a trademark of General Electric Company and is used under license to

Jasco Products Company LLC, 10 E. Memorial Road, Oklahoma City, OK 73114.

www.jascoproducts.com

Rev. 08-13-08

19214-2

Front Door Dip Switch

Rear Door Dip Switch

Chime

Rear

Door 

Button

Front

Door 

Button

1.875"

1.875"

1.875"

1.875"

5.5"