Garmin zumo 340LM Owner's Manual | Page 5

Garmin Motorcycles Owner's Manual - zumo 340LM.
Download
Page  of 26
4.3, 1987 votes
background image

Getting Started

 WARNING

See the Important Safety and Product Information guide in the 

product box for product warnings and other important 

information.

Mounting Your Device in a Motorcycle
About the Powered Mount Cables

 WARNING

Garmin® strongly recommends having an experienced installer 

with the proper knowledge of electrical systems install the 

device. Incorrectly wiring the power cable can result in damage 

to the vehicle or the battery and can cause bodily injury.
See the Important Safety and Product Information guide in the 

product box for product warnings and other important 

information.

The device must be mounted in a suitable and secure location 

on your motorcycle, based on available power sources and safe 

cable routing.

À

Motorcycle cradle

Á

Bare wires with inline fuse for power connection (to motorcycle 
power)

Installing the Handlebar Base
The device includes parts for two handlebar installation 

solutions. Custom mounts can require additional hardware 

(http://www.ram-mount.com).
Installing the U-bolt and Handlebar Base

Place the U-bolt 

À

 around the handlebar 

Á

, and thread the 

ends through the handlebar base 

Â

.

Tighten the nuts to secure the base.

NOTE: The recommended torque is 50 lbf-in. Do not exceed 

torque of 80 lbf-in.

Installing the Handlebar Base to the Clutch-Clamp or Brake-

Clamp Brackets

Remove the two factory bolts on your clutch-clamp or brake-

clamp bracket 

À

.

NOTE: Both 1/4 in. standard and M6 bolts are included. 

Match the size of the factory bolts on your clutch-clamp or 

brake-clamp bracket.

Thread the new bolts 

Á

 through the handlebar base, spacers 

Â

, and clutch-clamp or brake-clamp bracket.

Tighten the bolts to secure the base.
Attaching the Power Cables to the Motorcycle Mount
Thread the power cable connector 

À

 through the top of the 

opening in the motorcycle mount.

Slide the cable down to the bottom of the opening 

Á

 and pull 

the cable back until it is snug.

Screw the black screw 

Â

 into the back of the mount 

Ã

 to 

hold the cable in place.

Thread the weather cap 

Ä

 through the top hole and press it 

into the hole.

Getting Started

1

0.683548s