Garmin GHP 12 Autopilot System Quick Start Manual

Garmin GPS Quick Start Manual - GHP 12 Autopilot System.
Download
Page  of 10
4.9, 1668 votes
background image

Class B Drive Unit Installation Instructions

To obtain the best performance and to avoid damage to your boat, install 

the Garmin® Class B Drive Unit according to the following instructions. 

Professional installation of the drive unit is highly recommended, because 

specific knowledge of rudder operation is required to properly install the 

drive unit.
Read all installation instructions before proceeding with the installation. 

If you experience difficulty during the installation, contact Garmin Product 

Support.

About the Class B Drive Unit

The Class B drive unit is a self-contained hydraulic drive unit that uses a 

solenoid clutch to extend and retract the rod that steers the tiller. Combined 

with the included rudder feedback sensor, the Garmin Class B Drive unit 

will provide the steering necessary for a Garmin autopilot when installed 

correctly.
Because the drive unit is self-contained, you do not need to connect or 

disconnect any of the hydraulic hoses. The system was filled and tested at the 

factory.

Registering Your Device

Help us better support you by completing our online registration today.
•  Go to http://my.garmin.com. 
•  Keep the original sales receipt, or a photocopy, in a safe place.

Contacting Garmin Product Support

Contact Garmin Product Support if you have any questions about this 

product. 
•  In the USA, go to www.garmin.com/support, or contact Garmin USA by 

phone at (913) 397.8200 or (800) 800.1020.

•  In the UK, contact Garmin (Europe) Ltd. by phone at 0808 2380000.
•  In Europe, go to www.garmin.com/support and click Contact Support 

for in-country support.

Important Safety Information

 WARnInG

You are responsible for the safe and prudent operation of your vessel. 

The Autopilot is a tool that will enhance your capability to operate your boat. 

It does not relieve you from the responsibility of safely operating your boat. 

Avoid navigational hazards and never leave the helm unattended.
See the Important Safety and Product Information guide in the autopilot 

product box for product warnings and other important information.

 CAUtIon

Failure to install and maintain this equipment in accordance with these 

instructions could result in damage or injury.
When in use, beware of hot motor and solenoid components, as well as the 

risk of entrapment from moving parts
Always wear safety goggles, ear protection, and a dust mask when drilling, 

cutting, or sanding.

Notice

This equipment should be installed by a qualified marine installer.
This equipment is only for use with Garmin autopilots.
The system was filled and tested at the factory, so you should not disconnect 

the hydraulic hoses to install the system. 
When drilling or cutting, always check the opposite side of the surface. Be 

aware of fuel tanks, electrical cables, and hydraulic hoses.

March 2011 

190-01289-06 Rev. B 

Printed in the UK

0.558426s