Garmin 4010 User's Manual | Page 8

Garmin Marine GPS System User's Manual - 4010.
Download
Page  of 68
4.5, 2044 votes
background image

GPSMAP® 4000/5000 Series Owner’s Manual

Getting Started

Getting  Started

Inserting and Removing SD Cards

Your unit supports Secure Digital (SD) cards. Insert optional BlueChart® g2 Vision® SD cards to 

view high-resolution satellite imagery, and aerial reference photos of ports, harbors, marinas, and 

other points of interest. Insert blank SD cards to transfer data such as waypoints, routes, and tracks 

to another compatible Garmin unit or a computer. The SD card slot is located on the lower-right 

corner of the unit.
To insert the SD card, open the access door and press the SD card in until it clicks. Press the card in 

again and release it to eject it from the chartplotter.

Card label

GPSMAP 4010 and 4012

Card label

GPSMAP 4008 and 5000 series

Restoring Factory Settings

You can restore your unit to the original factory settings.

  CAUtION: This procedure deletes any information you have entered.

To restore factory settings:

1.  From the Home screen, select 

Configure > System > System Information.

2.  Select 

Factory Settings.

3.  Select 

Reset to restore all factory settings or select Back to cancel.

Viewing System Information

You can view the software version, basemap version, and unit ID number for your chartplotter. 

You may need this information to update the system software or to purchase additional map data 

information.

From the Home screen, select 

Configure > System > System Information.

Using Simulator Mode

Simulator Mode turns the GPS receiver off for use indoors or for practice. The unit does not track 

satellites in simulator mode.

  CAUtION: Do not try to navigate using Simulator Mode because the GPS receiver is turned off. Any 

satellite signal strength bars shown are only simulations and do not represent the strength of actual 

satellite signals.

To turn Simulator Mode on:

1.  From the Home screen, select 

Configure > System > Simulator > On.

2.  Select 

Setup to set speed, track control, position, simulator time, and simulator date. 

Related Manuals for Garmin 4010

0.523552s