Extron electronic Extron Electronics Computer Accessories DTP DVI 230 D User's Manual

Extron electronic Computer Accessories User's Manual - Extron Electronics Computer Accessories DTP DVI 230 D.
Download
Page  of 2
4.7, 2093 votes
background image

DTP DVI 230 D and HDMI 230/330 D • Setup Guide

This setup guide provides instructions for an experienced installer to set up and operate the 
Extron DTP DVI 230 D and DTP HDMI 230 and 330 D extenders.

Installation

Step 1 — Prepare the Mounting Surface

NOTE: 

Use a wall box with a depth of at least 3.0 inches (7.6 cm). 

Alternatively, the included mud ring (MR 200) can be used. 
For more information, see the full product user guides at 
www.extron.com. The installation must comply with the 
National Electric Code.

a.  Place the wall box against the installation surface and mark the 

opening guidelines.

TIP:

    Use a level to mark the opening.

b.  Cut out the material from the marked area.
c.  Secure the wall box with 10-penny nails or #8 or 

#10 screws, leaving the front edge flush with the surface.

d.  Run all required cables (see steps 4, 5, and 6) and secure them with 

cable clamps.

TIP:

    In order to fit the unit in the junction box, do not install 

boots on TP cables and RJ-45 connectors.

Step 2 — Disconnect Power

Disconnect all equipment power sources.

Step 3 — Connect Inputs to the Transmitter

DVI or HDMI input connector — Connect a DVI or HDMI cable between this port and the output port of the digital video source. 

Local output (DTP DVI 230 D only) — If desired, connect a DVI monitor for local monitoring of the input digital image.

C  DDC Route DIP switch (DTP DVI 230 D only) — If the local output is not used, 

set the DDC Route DIP switch to remote. Ensure that you power the local display 
before powering the video source.

D  Audio input — Connect an unbalanced stereo audio source to this 3.5 mm mini 

stereo jack.

RS-232/IR Pass-Through connector — Plug an RS-232 or modulated IR device 
into the RS-232/IR Pass-Through port. Wire the cable as shown to the right.

Ground

Receive pin on connected unit

Transmit pin on connected unit

Connected RS-232

and IR Device Pins

Tx/Rx

Pins

Receive pin on connected unit

Transmit pin on connected unit

Rx

Tx

RS-232

  

IR

Rx

Tx

G

Signal Output

Cable

Cable

Clamp

Decora Faceplate

Extron

DTP DVI 230 D

Screws or

Nails

Wall opening is

flush with edge of box.

Wall Stud

LOCAL OU

T

Tx

Rx

G

Tx

Rx

RS-232

IR

INPUTS

DVI-

D

AUDI

O

INPUTS

LOCAL OU

T

DVI-

D

AUDI

O

Tx

Rx

G

Tx

Rx

RS-232

IR

INPUTS

LOCAL OUT

DVI-D

AUDIO

REMOTE

DDC

ROUTE

LOCAL

Tx Rx G Tx Rx

RS-232

IR

ON

1 2

INPUTS

AUDIO

Tx Rx G Tx Rx

RS-232

IR

OVER DTP

DTP DVI 230 D Tx

DTP HDMI 230/330 D Tx

Related Manuals for Extron electronic Extron Electronics Computer Accessories DTP DVI 230 D

0.633949s