Epson Epson Stylus Pro 4000 Print Engine Start Here Card

Epson Print Engine Start Here Card - Epson Stylus Pro 4000 Print Engine.
Download
Page  of 6
4.4, 1463 votes
background image

Load Roll Paper

1

Slide the black paper stop off the end of 
the spindle.

2

If the paper has a 2-inch core, remove the adapters
by pressing the four tabs.

Note:

Make sure your hands are clean, and avoid touching the printable surface of the paper.

Try to handle paper by the edges. Make sure you don’t rub or scratch the coating or dent the
edges of the paper.

3

Position the roll so the paper unwinds as shown,
then slide it onto the spindle.

4

Slide the black paper stop back onto the spindle.
Insert it firmly into the end of the roll.

5

Open the roll paper cover.

6

Place the paper and spindle in the printer as
shown, with the gray end on the right.

7

Make sure the printer is powered on and
ready. Press the 

Paper Source button until

the 

or 

roll paper icon appears.

8

Release the paper lever.

9

Hold both sides of the paper and feed it into the slot until the paper
is aligned with the OTHER mark and the vertical line on the paper tray 
cover. Then move the paper lever to the secured position.

10 Raise the roll paper support on top of the

paper tray. Then close the roll paper cover.

EPSON Stylus® Pro 4000

Unpack 

1

Make sure you have all the parts shown below for your EPSON Stylus Pro 4000:

Warning:

The printer weighs about 85 pounds, and should be lifted by two people.

2

Remove all the packing materials and
tape. Save the box and packaging in case
you need to ship the printer.

3

Loosen the two screws and remove the
carriage retainer bracket.

4

Unlock the print head carriage by
pulling the green tab to the left. Do
not remove the tab.

Note:

To lock the print head carriage

for transportation, push the green tab to
the right.

Set Up and Plug In

1

Connect the power cord to the AC 
inlet on the back of the printer.

2

Plug the other end of the power 
cord into a properly grounded 
electrical outlet.

3

Attach the exhaust port cover by sliding it
along the slots on the back of the printer.

4

Insert the paper tray into the slots at
the front of the printer.

Paper tray

Printer

Ink cartridges

Power cord

Roll paper spindle

Spindle adapters

(attached to spindle)

Start Here

Start Her

Power button

AC inlet

Paper
Source
button

Roll paper cover

Exhaust port cover

vertical line

OTHER mark

CPD17011R1_Isa_SH_E.qxd  9/21/04  5:13 PM  Page 1

Related Manuals for Epson Epson Stylus Pro 4000 Print Engine

0.640371s