Electrolux Diva Service Manual | Page 18

Electrolux Dishwasher Service Manual - Diva.
Download
Page  of 32
4.1, 2417 votes
background image

 

SOI/TD - PR 

18/32 

599 38 72-30 

3.3  SUMP ASSEMBLY 
 

The  sump  is  a  monobloc  container  in  plastic  material,  and  consists  of  three  thermowelded  sections: 
PRESSURE, WASHING and DRAIN. 
The  sump  is  located  on  the  bottom  of  the  tub,  with  a  perimetral 
sealing ring, and is secured from the inside by four screws. 

 

 

PRESSURE section (A

An  integral  part  of  the  WASHING  section,  in  which  a  double 
pressure chamber controls the level of the water. 

 

 

WASHING section (B

Located beneath the main stainless steel filter, this section collects 
the filtered water, which is then re-introduced (clean) into the circuit 
and ducted to the spray arms. 
-  Direct hydraulic connection to the lower spray arm. 

 

 

DRAIN section (C

Located beneath the circular filter in the bottom of the sump, where 
the dirt is deposited before being drained. 
-  Housing for the drain filter. 

 

Four  ball  valves  built  into  the  sump  perform  a  number  of  specific 
functions. 

 

Pressure switch pressure valves (2): 

-  Positioned inside the respective pressure chambers. 
-  In  case  of  tilting  of  the  appliance,  the  valves  prevent  the 

residual water in the sump from entering the connections of the 
two pressure switch tubes. 

 

Drain pump breather valve: 

-  This valve is located internally, near the drain pump breather. 
-  During the water fill phase,  the valve opens and maintains the 

drain  circuit  open  so  that  the  air  is  expelled.  This  enables  the 
pump to fill with water and prevents cavitation. 

 

Sump bottom valve: 

-  Located internally, near the sump bottom. 
-  During the water fill phase, the valve closes to separate the drain section from the washing section. 
-  During the drain phase, the valve opens, thus connecting the drain and washing sections. 
The following connections are located externally: 
-  Hydraulic connection to the softener via a rubber hose 
-  Hydraulic connection to the drain pump, via a rubber coupling 
-  Hydraulic connection to the washing pump, via a rubber coupling 
-  Housing for the thermostat or temperature/turbidity sensor 
-  To the level and safety pressure switches, via two small tubes of different colours. 

 

 

3.4  DRYING DUCT  

 

The drying duct is a moulded plastic container consisting of two 
sections  which  are  pressure-fitted  together.  The  drying  duct  is 
used in Active and Turbo drying. 
During  the  drying  phase,  the  function  of  the  duct  is  to  transfer 
the steam from inside the tub into the fill tank condenser, where 
it is condensed. 
The drying duct is positioned externally above the tub and fixed 
from the inside by a snap ring. 

 
3.4.1  DRYING DUCT + FAN 

Turbo  drying  is  obtained  by  means  of  a  fan  located  inside  the 
drying duct. 
The  fan  consists  of  a  small  synchronous  electric  motor  and  an 
elastic drive belt which actions the suction fan blade. 
When the fan is in operation, it creates a forced air movement. 

 

0.482023s