De'Longhi pinguino pac ct90 User's Manual | Page 2
Setting up your portable
TO AVOID DAMAGE TO THE UNIT:
NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR ON ITS SIDE. IF THIS OCCURS, WAIT
6 HOURS BEFORE TURNING THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. (After the unit has
been on its side, oil needs to return to the compressor to ensure proper function. Without allow-
ing the unit this time (6-24 hours) The unit may function for only a short time, and then the com-
pressor will break down from lack of oil.)
Before plugging the appliance into the outlet, check that:
The outlet’s power supply corresponds to the value indicated on the rating label on the back
of the appliance;
The outlet and electrical circuit are adequate for the appliance;
The outlet is a 3-hole grounded outlet . If this is not the case, you must choose another outlet.
Failure to follow these important safety instructions absolves the manufacturer of all liability.
The instructions below will enable you to prepare your air conditioner for operation as efficiently
as possible. Before use, make sure the air intake and outlet grilles are unobstructed.
If it becomes necessary, the power cable must be replaced by a qualified professional only.
Other set-up methods:
Thanks to the locking pins, it’s possible to
use the window bracket also for sliding
windows. Position the hole of the bracket
so to allow a correct installation of the
exhaust hose (see figure C).
If you have a casement window (figure D)
follow steps 2 & 3 and place the window
outlet (12) outside the window to exhaust
the hot air.
For help with installation, operation, and
for all accessories and spare/replacement
parts, Please contact our toll free cus-
tomer service call center at:
1-800-322-3848 [US only]
Monday – Friday 8:30am – 5:00pm ET Or
log onto our website at
AIR CONDITIONING WITHOUT INSTALLATION
NOTE: Keep the air hoses as short and free of
curves as possible to avoid constrictions.
FOR OPTIMAL RESULTS SET-UP IN A DOU-
1) Place the bracket in the window sill,
extend the bracket fully within the window
frame, fix the bracket by using the pin
then lower the window onto the bracket.
(Should the window bracket be too large
for the window. The plastic can be cut
with a saw by a qualified professional.)
2) Fit the air exhaust hose in the housing at
the back of the appliance. Insert it as
shown in figure A.
3) Connect the window outlet (12) to the
other end of the exhaust hose.
4) Insert the window outlet end of the exhau-
st hose into the slot of the window bracket
Related Manuals for De'Longhi pinguino pac ct90
Carrier Air Conditioners 24ABB3 Owner's Manual
Vicks Air Conditioners V1200 Owner's Manual
Trane Air Conditioners XL15i Owner's Manual
Oreck Air Conditioners AIR12GU Owner's Manual
Hunter Air Conditioners 30200 Owner's Manual
Heat Controller Air Conditioners InverterFlex Series Owner's Manual
Heat Controller Air Conditioners Patriot 80 Series Owner's Manual
De'Longhi Air Conditioners PAC A110 Owner's Manual
Trane Air Conditioners XE1000 Owner's Manual
Mitsubishi Air Conditioners R410A User's Manual
Sharp Air Conditioners CV10NH - 10,000 BTU Portable Air Conditioner Installation Manual
White Rodgers Air Conditioners 1F78 User's Manual
Goldstar Air Conditioners GWHD5000 Owner's Manual
Duracraft Air Conditioners AMD-8500E User's Manual
Trane Air Conditioners RTAC 140-400 User's Manual
Haier Air Conditioners Commercial Cool CPN10XCJ User's Manual
Haier Air Conditioners HSU-09HV03/R2(SDB) User's Manual
Carrier Air Conditioners 30GB User's Manual
Comfort-Aire Air Conditioners Air Conditioner PAD-121 User's Manual
Kul Air Conditioners KU32085 User's Manual
Danby Air Conditioners DPA140HB1WDD User's Manual
Trane Air Conditioners XR14 User's Manual
Frigidaire Air Conditioners FFRH0822R1 Installation Instructions
Arctic King Air Conditioners WINDOW/WALL TYPE ROOM AIR CONDITIONER User's Manual