Cub Cadet SERIES 7000 7264 Operator's Manual | Page 35
35
•
If the oil level is low, add Cub Cadet hydraulic
oil. Loosely position a funnel in the fill hole so
that there is enough clearance around the fun-
nel to allow the transmission to vent while the
oil is poured into the transmission. Fill ONLY to
the full mark, never overfill the transmission.
NOTE: Always use Cub Cadet hydraulic oil to
ensure correct formulation. Substitute oils could
affect performance and may cause damage to the
transmission.
•
Reinsert the oil fill plug /dipstick into the
transmission housing and turn clockwise until
tight.
CHANGING TRANSMISSION /HYDRAULIC
SYSTEM OIL
Change the hydrostatic transmission /hydraulic
system oil after every 200 hours of operation. The
dry capacity of the transmission/hydraulic system is
approximately 24 quarts.
Change the transmission/hydraulic system oil as
follows:
•
Operate the tractor for a short period to warm
the oil to the normal operating temperature.
Place the tractor on a level surface, engage the
parking brake, and stop the tractor engine.
•
Remove any belly mounted attachments.
•
Clean the area around the transmission drain
plug and the oil fill plug/dipstick to prevent
debris from entering the transmission. Refer to
Figure 42 and Figure 43.
Figure 43
•
Place a suitable container(s) beneath the front
of the transmission housing.
•
Remove the oil fill plug/dipstick to help vent the
transmission, then remove the drain plug and
allow the transmission oil to drain into the
container(s). Reinstall the drain plug after
draining the oil. See Figure 43.
Dispose of used oil in an environmentally
safe manner. If necessary, contact your
area EPA office for proper disposal proce-
dures and recycling center locations.
•
Clean around the base of the hydrostatic
transmission oil filter and remove the filter by
turning it counterclockwise. See Figure 43.
•
Apply a light coating of clean transmission oil to
the gasket of the new filter. Install the filter by
turning it clockwise, by hand, until the gasket
contacts the filter base on the transmission
housing; then tighten the filter an additional 1/2
to 3/4 turn.
•
Clean around the base of the hydraulic system
oil filter and remove the filter by turning it
counterclockwise. Refer to Figure 43.
•
Apply a light coating of clean transmission oil to
the gasket of the new filter. Install the filter by
turning it clockwise, by hand, until the gasket
contacts the filter base on the transmission
housing; then tighten the filter an additional 1/2
to 3/4 turn.
•
Loosely position a funnel in the oil fill hole so
that there is enough clearance around the fun-
nel to allow the transmission to vent while the
oil is poured into the transmission. Fill ONLY to
the full mark on the dipstick, never overfill the
transmission.
NOTE: Always use Cub Cadet hydraulic oil and
filters to ensure correct formulation and filtering
capacity. Substitute oils and/or filters could affect
performance and may cause damage to the
transmission.
•
Reinsert the oil fill plug /dipstick into the
transmission housing and turn clockwise until
tight.
•
Start the engine and allow it to run for a few
minutes. Shut the engine off, then check for
leaks and recheck the oil level in the
transmission housing.
Viewed from beneath the Tractor
HYDRAULIC
SYSTEM
FILTER
TRANSMISSION
DRAIN PLUG
HYDROSTATIC
OIL FILTER
(723-3014)
(723-0405)
Related Manuals for Cub Cadet SERIES 7000 7264
-
Husqvarna Lawn Mowers YTH24V48, 96045004600, 2013-09 Owner's Manual
68 pages
-
Troy-Bilt Lawn Mowers TB30 R Neighborhood Rider Owner's Manual
72 pages
-
Troy-Bilt Lawn Mowers Horse XP Lawn Tractor Owner's Manual
64 pages
-
Troy-Bilt Lawn Mowers Mustang 42 XP Zero-Turn Riding Lawn Mower Owner's Manual
80 pages
-
Troy-Bilt Lawn Mowers Mustang 50 XP Zero-Turn Riding Lawn Mower Owner's Manual
80 pages
-
Homelite Lawn Mowers UT13126 Owner's Manual
20 pages
-
Honda Lawn Mowers H4518H 1000001-9999999 Owner's Manual
93 pages
-
Craftsman Lawn Mowers 917 Owner's Manual
60 pages
-
Exmark Lawn Mowers LAZER Z 103-0656 Parts Manual
40 pages
-
Yard Works Lawn Mowers Yardworks 60-1620-4 Owner's Manual
32 pages
-
Simplicity Lawn Mowers 4211 Series Parts Manual
46 pages
-
Ariens Lawn Mowers 915164 GRAVELY ZT XL 54 User's Manual
5 pages
-
Exmark Lawn Mowers Quest Lawn Mower User's Manual
56 pages
-
John Deere Lawn Mowers 2305 User's Manual
8 pages
-
John Deere Lawn Mowers 2320 User's Manual
8 pages
-
John Deere Lawn Mowers 2520 User's Manual
8 pages
-
John Deere Lawn Mowers 3032E User's Manual
16 pages
-
John Deere Lawn Mowers 3720 User's Manual
16 pages
-
John Deere Lawn Mowers 3520 User's Manual
16 pages
-
John Deere Lawn Mowers 4105 User's Manual
12 pages
-
John Deere Lawn Mowers 4720 User's Manual
12 pages
-
John Deere Lawn Mowers 100 Series User's Manual
52 pages
-
John Deere Lawn Mowers LA175 User's Manual
1 pages
-
King Kutter Lawn Mowers Free Floating Finishing Mower User's Manual
44 pages