Craftsman pmn Instruction Manual | Page 21

Craftsman Routers Instruction Manual - pmn.
Download
Page  of 35
4.6, 1892 votes
background image

-20-

Router Table 

for the Craftsman

U.

Assembly of Profiling Top Guard

The use of the optional accessory, Profiling Top Guard
is highly recommended to safely carry out the profiling of
workpieces with a bearing guided cutter. It will prevent
the operator's fingers inadvertantly contacting the cutter.

1.

Fit the BoltStar WasherSpring Washer and Nut
in the sequence as indicated below.

2.

Tighten nut securely with a 8mm spanner.

3.

Fit PlateWasher and Wing Nut.

4.

Slide the Perspex Guard in between the Plate and
edge of Table Surface.

5.

Gently tighten Wing Nuts.

Adjustment

1.

The height of the Perspex Guard should be
adjusted to leave a 6mm to 12mm gap between the
top of the workpiece and the underside of the
guard. This will prevent fingers coming into contact
with the cutter.

2.

To adjust the height undo the wing nuts, re-position
the guard and retighten.

Section Y describes a typical application involving the
use of bearing guided cutters with the Router Table.

fig. T

Wing Nut

Washer

Plate

Half Nut

Spring Washer

Star Washer

Perspex Guard

M5 Bolt

Profiling Top Guard - CRT/2

0.500624s