Craftsman C3 19.2-Volt 6 1/2-in. Circular Saw Owner's Manual | Page 8

Craftsman Circular Saw Owner's Manual - C3 19.2-Volt 6 1/2-in. Circular Saw.
Download
Page  of 32
4.4, 1432 votes
background image

8 – English

  Fit saw blade inside lower blade guard and onto 

spindle. 

 NOTE: The saw teeth point upward at the front of saw 

as shown in figure 2.

  Replace outer blade washer.

  Depress spindle lock button, then replace blade screw. 

Tighten blade screw securely by turning counterclock-
wise.

  Return blade wrench to storage area.

NOTE: Never use a blade that is too thick to allow the 
outer blade washer to engage with the flats on the 
spindle.

REMOVING THE BLADE
See Figure 3, page i.
 

Remove the battery pack from the saw.

 

Remove blade wrench from storage area.

 

Position the saw as shown, depress the spindle lock 
button, and remove the blade screw by turning it 
clockwise.

 

Remove outer blade washer.

 

Remove the blade.

ATTACHING THE BLADE
See Figure 2, page i.

WARNING: A 6-1/2 in. blade is the maximum blade 
capacity of the saw. Never use a blade that is too 
thick to allow outer blade washer to engage with the 
flats on the spindle. Larger blades will come in con-
tact with the blade guard, while thicker blades will 
prevent blade screw from securing blade on spindle. 
Either of these situations could result in a serious 
accident.

 

Remove the battery pack from the saw.

 

Remove blade wrench (5 mm hex key) from storage 
area.

 

Depress spindle lock button and remove blade screw 
and outer blade washer.

NOTE: Turn blade screw clockwise to remove.

NOTICE: To prevent damage to the spindle or 

spindle lock, always allow motor to come to a 
complete stop before engaging spindle lock.

 NOTE: 

Do not run the circular saw with spindle lock 

engaged.

 

Wipe a drop of oil onto inner blade washer and outer 
blade washer where they contact blade.

WARNING:

 If inner blade washer has been  

removed, replace it before placing blade on spindle. 
The larger diameter of the inner blade washer should 
be placed against the blade. Failure to do so could 
cause an accident since blade will not tighten  
properly.

ASSEMBLY

Related Manuals for Craftsman C3 19.2-Volt 6 1/2-in. Circular Saw

0.569891s