Craftsman 5-Drawer Standard Duty Ball-Bearing Tool Center - Black Use & Care Manual | Page 4
4
Slide
Stop
Slide Carrier
Slide
• Insert the lockbar (which stores in the top tray), tabbed
end up, into the slot in the top tray and down into the
slot in the base. Close the cover and lock with the key.
toloCKCHest
• The lockbar for the rol -away is stored in a slot in the top
front corner of the unit.
• Insert the straight end of the lockbar into the slot in
the base.
• Move the lockbar toward the unit until the bent end fits
into the slot near the lock. Lock with the key.
toloCKRoll-aWay
• If your unit is equipped with a storage compartment with
a panel at the bottom, pull panel out, lift up and push
panel back into unit to gain access to compartment.
paNel
Ballbearingslide - Pull slides and slide carrier out to fully
extended position (see illustration). Hold the slide on the
cabinet while aligning it with the slide on drawer. Slightly
insert one side and repeat for the other side. Slowly push
drawer to its fully closed position to engage slide. Open
drawer and reclose to ensure proper operation.
ReINstallDRaWeRs
frictionslide - Fully extend slides in cabinet. Hold the
slide on the cabinet while aligning it with the slide on
drawer. Push the drawer into the unit until the drawer
fully engages slides. Open drawer and reclose to ensure
proper operation. (If stop does not engage slide, lightly
deflect the stop with screwdriver.)
RemovINGaNDINstallINGslIDesfRomuNIt
• First remove the drawer. (See section A)
toremovetheslide:
• Push slide to the closed position.
• Insert flat tip screw driver between slide and unit, behind
rear rectangular cutout.(See illustration.)
• Rotate screw driver ¼ turn to force slide away from unit.
• Push on front of slide pushing it towards back of the unit.
toattachtheslide:
• Extend slide and locate lances within respective
cutout in carrier.
• Pull slide forward until slide locks back into place.
• Reinstall drawer following drawer installation proce-
dure.(See section B)