Craftsman 19.2 volt Replacement Battery Pack Owner's Manual | Page 2

Craftsman Batteries and Chargers Owner's Manual - 19.2 volt Replacement Battery Pack.
Download
Page  of 4
4.6, 2155 votes
background image

bATTERY PACK REmOVAL AnD 
PREPARATIOn FOR RECYCLInG

To preserve natural resources, please re-

cycle or dispose of batteries  properly.
This product contains nickel- cadmium bat-

teries. Local, state or federal laws may pro-

hibit disposal of nickel- cadmium batteries in 

ordinary trash.

Consult your local waste authority for information  regarding 

available recycling and/or disposal options. 

WARnInG: Upon removal, cover the battery pack’s 

terminals with heavy-duty adhesive tape. Do not 

attempt to destroy or disassemble battery pack or 

remove any of its components. Nickel-cadmium 

batteries must be recycled or disposed of properly. 

Also, never touch both terminals with metal objects 

and/or body parts as short circuit may result. Keep 

away from children. Failure to comply with these warn-

ings could result in fire and/or serious injury.

®

  Red LED should remain on for approximately 1 hour 

then the green LED will come on. Green LED on 

indicates battery pack is fully charged and charger is in 

maintenance charge mode. 

 

nOTE: The green LED will remain on until the battery pack 

is removed from the charger or charger is 

disconnected from the power supply.

  If both yellow and green LEDs come on, this indicates a 

deeply discharged or defective battery pack. Allow the 

battery pack to remain in the charger for 15 to 30 minutes. 

When the battery pack reaches normal 

voltage range, the red LED should come on. If the red LED 

does not come on after 30 minutes, this may 

indicate a defective battery pack and should be 

replaced.

  After normal usage, a minimum of 1 hour of charging time 

is required to fully recharge battery pack. 

  The battery pack will become slightly warm to the touch 

while charging. This is normal and does not 

indicate a problem.

  Do not place the charger and battery pack in an area of 

extreme heat or cold. They will work best at normal room 

temperature. 

  nOTE: The charger and battery pack should be placed in 

a location where the temperature is more than 50°F but 

less than 100°F.

When batteries become fully charged, unplug the 

charger from power supply and remove the battery pack.

990000301
9-28-12 (REV:01)

 

SAVE THESE INSTRUCTIONS

OPERATIOn

mAInTEnAnCE

Orchard Supply Hardware, San Jose, CA 95119 USA

Visit the Craftsman web page: www.craftsman.com

1-800-4-mY-HOmE®        1-800-488-1222

CHARGER

BATTERY PACK 11375 

IN CHARGER 11041

YEllow 

lED

RED lED

Fig. 1

GREEN 

lED

bATTERIES
The battery pack is equipped with nickel-cadmium recharge-

able batteries. Length of service from each charging will 

depend on the type of work you are doing.
The batteries have been designed to provide maximum 

trouble-free life. However, like all batteries, they will eventual-

ly wear out. 

Do not disassemble battery pack and attempt to 

replace the batteries. Handling of these batteries, especially 

when wearing rings and jewelry, could result in a serious 

burn.
To obtain the longest possible battery life, we suggest the 

following:

  Remove the battery pack from the charger once it is fully 

charged and ready for use.

For battery pack storage longer than 30 days:

  Store the battery pack where the temperature is below 

80°F.

  Store battery packs in a “discharged” condition.

Also See for Craftsman 19.2 volt Replacement Battery Pack

0.575008s