Craftsman 15 Drill Press with Laser and LED Light Owner's Manual | Page 6

Craftsman Drill Presses Owner's Manual - 15 Drill Press with Laser and LED Light.
Download
Page  of 34
4.4, 1566 votes
background image

6

CARTON CONTENTS

UNPACKING AND CHECKING CONTENTS

Carefully unpack the Drill Press and all its parts, and compare against the 

illustration following. 

WARNING: 

•  To avoid injury from unexpected starting, do not plug the power cord into a  

   power source receptacle during unpacking and assembly. This cord must  

   remain unplugged whenever you are assembling or adjusting the drill press.

•  If any part is missing or damaged, do not plug the drill press in until the miss-  

   ing or damaged part is replaced, and assembly is complete.

•  To protect the drill press from moisture, a protective coating has been applied  

   to the machined surfaces.

   Remove this coating with a soft cloth moistened with kerosene .

WARNING: To avoid fire or toxic reaction, never use gasoline, naphtha, acetone, 

lacquer thinner or similar highly volatile solvents to clean the drill press.

TABLE OF LOOSE PARTS

Unpack carton; check the machine to see parts listed below:

A.   Main parts :   

See Fig. 1 

      1. Head assembly   

                                               

      2. Column Assembly                                           

      3. Table                          

                  

      4. Base                                      

      

5. ON/OFF Switch

       

6. Flexible Lamp            

       
      

To turn on drill press, lift paddle switch from bottom.

     To turn off drill press, push paddle switch down. 

      To prevent unauthorized use, remove the center key from the 

      switch. 

Figure 1B and 1C

      Drill press cannot be turned 

ON if key is not inserted. 

                                                                              

FIGURE 1

ACCESSORIES AND ATTACHMENTS

 

 

 

 

1

2

3

4

 

5

FIGURE 1B

FIGURE 1C

 

6

0.561950s