Craftsman 15 Drill Press with Laser and LED Light Owner's Manual | Page 10

Craftsman Drill Presses Owner's Manual - 15 Drill Press with Laser and LED Light.
Download
Page  of 34
4.4, 1566 votes
background image

Figure 9

Figure 10

Figure 11

Clamp bolt

Crank 

handle

1. Table adjustment

B. Height adjustment 

     Loosen the clamp bolt then adjust the table to your desired position by    

     turning the table bracket crank handle. 

See Fig. 11

C. Swing Adjustment 360°

     Loosen the table swing locking handle, then swing table to desired 

     position and retighten the handle. 

See Fig. 12

ADJUSTMENT

10

Table Swing Locking 

Handle

Figure 12

  A. Tilting adjustment: 

- On underside of table support bracket, loosen the nut (right-handed  rotation) 

with an open end wrench and back out the threaded  pin. Loosen large hex  
head bolt.

See Fig.9 

- Rotate table to desired angle right or left. Use bevel scale for precise setting. 

See Fig.10

- Tighten hex head bolt to secure table tilt. Threaded pin should not come into  

the hole when table is tilted. 

- To return table to level, loosen large hex head bolt. Rotate table to level 

position. Make nut and thread pin end at the same level position, then push 
the thread pin into the hole. Securely tighten large hex head bolt. 

0.574877s