Craftsman 12 Drill Press with Laser and LED Light Owner's Manual | Page 8

Craftsman Drill Presses Owner's Manual - 12 Drill Press with Laser and LED Light.
Download
Page  of 34
4.3, 1604 votes
background image

8

Figure 3

Figure 4

1. Column support to base

    1.2 Place the column on the base, aligning the holes in the column   

          support with the holes in the base.

    1.3 Locate the four long hex bolts from the loose parts bag.

    1.4 Place a bolt in each hole through the column support and the  

          base. Tighten with an adjustable wrench. 

See Fig. 1

  

3. Installing head assembly

    3.1. Carefully lift the head above the column and slide it onto the  

           column.

           Make sure the head slides down over the column as far as 

           possible.

           Align the head with the base.

    3.2. Using the hex wrench, tighten the head lock set screws.

 

See Fig. 4

4. Installing feed handles

    4.1. Locate the three feed handles in the loose parts box.

    4.2. Screw the feed handles into the threaded holes in the hub.  

           Tighten.

 

See Fig. 5.

ASSEMBLY

Figure 1

Figure 2C

Figure 5

2. Installing the Table

  2.1 Loosen set screw (1). Remove rack (2) and retaining ring (3) from  

        column (4). 

Fig. 2A

  2.2 Place rack inside table assembly bracket (5) with large, unma-   

        chined portion of rack to the top. Slide rack into slot in bracket so  

        that teeth of rack engage pinion gear in bracket. 

Fig. 2A

  2.3 Slide table assembly with rack over column. Place bottom end of  

  2.4 Slide rack retaining ring (3) over column with beveled edge down.  

        Position ring against top of rack so that rack is in beveled edge of  

        ring. 

Fig. 2B Secure ring with hex wrench (1). Fig. 2C

  2.5 Rotate table assembly around column. Adjust rack retaining ring  

        as necessary to prevent binding of rack.

  2.6 Attach crank handle (6) to shaft (7), rotate to remove slack, and  

        shoulder crank handle against table bracket. Secure handle with  

        screw. 

Fig. 2B

  2.7 Tighten table bracket locking handle (9) to secure table assembly.

         

Fig. 3

Figure 2A

Figure 2B

0.593548s