Craftsman 10 Table Saw with Laser Trac (21807) Owner's Manual | Page 6

Craftsman Table Saws Owner's Manual - 10 Table Saw with Laser Trac (21807).
Download
Page  of 56
4.9, 1675 votes
background image

6

7

6

12.

ALWAYS WEAR EYE 

PROTECTION. Any power 
tool can throw foreign 
objects into the eyes and 
could cause permanent 

eye damage. 

ALWAYS wear Safety 

Goggles (not glasses) that comply 
with ANSI Safety standard Z87.1. 
Everyday eyeglasses have only 
impact–resistant lenses. They 
ARE NOT safety glasses. Safety 
Goggles are available at Sears. 
NOTE: Glasses or goggles not in 
compliance with ANSI Z87.1 could 
seriously injure you when they break.

13.

WEAR A FACE MASK OR DUST 

MASK. Sawing operation produces 
dust.

14.

SECURE WORK. Use clamps or 

a vise to hold work when 
practical. It is safer than 
using your hand and 
it frees both hands to 
operate the tool.

15.

DISCONNECT TOOLS FROM 

POWER SOURCE before servicing, 
and when changing accessories 
such as blades, bits and cutters.

16.

REDUCE THE RISK OF 

UNINTENTIONAL STARTING
Make sure switch is in the OFF 
position before plugging the tool in.

17.

USE RECOMMENDED 

ACCESSORIES. Consult 
this Operator’s Manual for 
recommended accessories. The use 
of improper accessories may cause 
risk of injury to yourself or others.

18.

NEVER STAND ON THE TOOL

Serious injury could occur if the 
tool is tipped or if the cutting tool is 
unintentionally contacted.

19.

CHECK FOR DAMAGED PARTS

Before further use of the tool, a 
guard or other part that is damaged 
should be carefully checked to 
determine that it will operate 
properly and perform its intended 
function – check for alignment of 
moving parts, binding of moving 
parts, breakage of parts, mounting 
and any other conditions that may 
affect its operation. A guard or other 
part that is damaged should be 
properly repaired or replaced.

20.

NEVER LEAVE THE TOOL 

RUNNING UNATTENDED. TURN 
THE POWER “OFF”.
 Do not walk 
away from a running tool until the 
blade comes to a complete stop 
and the tool is unplugged from the 
power source.

21.

DO NOT OVERREACH. Keep 

proper footing and balance at all 
times.

0.563642s