Coleman 8100 Series User's Manual

Coleman Gas Grill User's Manual - 8100 Series.
Download
Page  of 16
4.1, 1480 votes
background image

Natural Gas Conversion Kit

IMPORTANT

Read this document carefully before attempting installation
of this conversion kit. These instructions should be left with
the consumer for future reference.

For the following Coleman® Gas Barbecue Grills:

8100 Series (M/N 9992-643)
8200 Series (M/N 9992-644)

WARNING

• This Natural Gas conversion Kit must be installed only by a qualified

service technician.

• Gas supply system must be installed in accordance with the U.S.

National Fuel Gas Code.

• This appliance and its individual shut off valve must be disconnected

from the gas supply piping system during any system pressure test in
excess of 1/2 PSI (3.5 KPA).

• Use a system manual shut off valve to shut off the gas supply to this

gas appliance before continuing with installation procedures.

WARNING

• If the information in this document is not followed exactly, a fire or

explosion may result causing property damage, personal injury or loss
of life. Read the Coleman® 

Gas Barbecue Use, Care & Assembly

Manual With Grill Lighting Instructions, before attempting installation
of this conversion kit.

WARNING

• TURN OFF THE GAS SUPPLY!

DO NOT attempt to install this Natural Gas Conversion Kit

while the barbecue is in operation or is hot.

Installation and provision for combustion and ventilation air
must conform with the 

National Fuel Gas Code, ANSI Z223.1,

or 

CAN/CGA-B149.1, Natural Gas Installation Code, or

CAN/CGA-B149.2, Propane Installation Code.

WARNING

A liquid propane tank, not connected for use with this gas barbecue,

shall not be stored in the vicinity of this or any other appliance.

Note: These instructions apply to

more than one model grill. The

parts included are designed for

your specific grill. The

illustrations may differ slightly

from model to model.

Turn off LP tank and disconnect
regulator from tank prior to servicing grill.

Connections must comply with local requirements and are the sole responsibility of the person performing

the work. A certified plumber must make connection to gas source. All codes must be followed.

0.533772s