Chamberlain 940EV Wireless Keyless Entry User's Manual

Chamberlain Garage Door Controls User's Manual - 940EV Wireless Keyless Entry.
Download
Page  of 2
4.1, 2076 votes
background image

+

Press and hold 
the     and # 
buttons until 
the lights on the
keypad stop
blinking.

1

2

Enter a 4-digit 
personal
identification 
number (PIN)
of your choice:

3

4

Press 0 to 
complete the 
programming.

5

The garage door 
opener will activate.

6

?  ?  ?  ?

?  ?  ?  ?

PIN

Press and release the ENTER 
button...

1

?  ?  ?  ?

Press the programmed PIN
that you want to change. 

...the light bulb blinks twice. 

Press and hold the 

# button until...

3

+

?  ?  ?  ?

new PIN

Enter the new 4-digit PIN of your choice,
then press the ENTER button.   

To test, press the PIN, then press the ENTER button.

To test, press the new PIN, 

then the ENTER button. 
The garage door opener 
will activate.

The light bulb will blink once.  

Check to see if the 
light bulb blinks. 
If not, slowly 
press and release 
the ENTER button 
until the light bulb 
blinks. Be careful NOT to 
          press the ENTER button after the 
             light bulb blinks.

*

           Press and 
     release the 
  Learn button.
The LED will light.
Within 30 seconds...

Locate the Learn button on the 
garage door opener.
NOTE: Your garage door opener may 
look different.

Learn 
LED

Learn 
LED

Learn 
LED

Green
or
Red/Orange

Purple

Yellow

To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
•  Install Keyless Entry Control within sight of the garage door, out of reach of children at a minimum height of 5 feet (1.5 m), and 

away from ALL moving parts of door.

•  ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote controls.
•  Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.
•  ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.

* For garage door openers that have a green Learn button or an external receiver repeat "Program Initial PIN" to change the existing PIN.

To program the Keyless Entry to more than one garage door opener, repeat the steps above using a new PIN for each additional garage door opener.

WIRELESS KEYLESS ENTRY  MODELS 940EV AND 940EVC

For use with Chamberlain 315 MHz or 390 MHz garage door 
openers manufactured after January 1, 1993. The garage door 
opener activates when the 4-digit Personal Identification Number 
(PIN) and ENTER button are pressed on the Keyless Entry.  

Install the battery and program the Keyless Entry prior to 
installation. Make sure the garage door opener has a working 
light bulb because it is a programming indicator.

0.581422s