Casio Casio Watch MO0804-EA User's Manual

Casio Watches User's Manual - Casio Watch MO0804-EA.
Download
Page  of 9
4.5, 1871 votes
background image

Operation Guide 3144

1

MO0804-EA

Getting Acquainted

Congratulations upon your selection of this CASIO watch. To get the most out
of your purchase, be sure to read this manual carefully.

Keep the watch exposed to bright light

The electricity generated by the solar cell of the
watch is stored by a built-in battery. Leaving or
using the watch where it is not exposed to light
causes the battery to run down. Make sure the
watch is exposed to light as much as possible.

• When you are not wearing the watch on your

wrist, position the face so it is pointed at a
source of bright light.

• You should try to keep the watch outside of

your sleeve as much as possible. Charging is
reduced significantly if the face is covered only
partially.

ll

l

l

l

l

l

l

l

l

l

Bright light

Solar cell

• The watch continues to operate, even when it is not exposed to light.

Leaving the watch in the dark can cause the battery to run down, which will
result in some watch functions being disabled. If the battery goes dead, you
will have to re-configure watch settings after recharging. To ensure normal
watch operation, be sure to keep it exposed to light as much as possible.

Bright light

Electrical 
energy

All 
functions
enabled

LEVEL 1

LEVEL 2

LEVEL 3

LEVEL 4

Charge

Solar cell
(Converts light to 
electrical power.)

Rechargeable battery

LEVEL 1

LEVEL 2

LEVEL 3

LEVEL 4

Some 
functions 
disabled

Dis-

charge

Battery charges in the light.

Battery discharges in the dark.

If the display of the watch is blank...
If the display of the watch is blank, it means that the watch’s Power Saving
function has turned off the display to conserve power.

• See “Power Saving” for more information.

Applications
The built-in sensors of this watch measure barometric pressure, temperature
and altitude. Measured values are then shown on the display. Such features
make this watch useful when hiking, mountain climbing, or when engaging in
other such outdoor activities.

Warning!

• The measurement functions built into this watch are not intended for

taking measurements that require professional or industrial precision.
Values produced by this watch should be considered as reasonable
representations only.

• CASIO COMPUTER CO., LTD. assumes no responsibility for any loss,

or any claims by third parties that may arise through the use of this
watch.

About This  Manual

• Button operations are indicated using the

letters shown in the illustration.

• Each section of this manual provides you with

the information you need to perform operations
in each mode. Further details and technical
information can be found in the “Reference”
section.

(Light)

• The actual level at which some functions are disabled depends on the

watch model.

• Frequent display illumination can run down the battery quickly and require

charging. The following guidelines give an idea of the charging time
required to recover from a single illumination operation.

Approximately five minutes exposure to bright sunlight coming in through
a window
Approximately 50 minutes exposure to indoor fluorescent lighting

• Be sure to read “Power Supply” for important information you need to

know when exposing the watch to bright light.

General Guide

• The illustration below shows which buttons you need to press to navigate

between modes.

• In any mode, press L to illuminate the display.

• You can use buttons B and D to enter a sensor mode directly from the

Timekeeping Mode or from another sensor mode. To enter a sensor mode
from the Data Recall, World Time, Stopwatch, Countdown Timer or Alarm
Mode, first enter the Timekeeping Mode and then press the applicable
button.

Timekeeping Mode

Altimeter Mode

World Time

Mode

Data Recall

Mode

Press C.

Press B.

Countdown

Timer Mode

Press C.

Sensor Modes

Stopwatch Mode

Barometer/

Thermometer Mode

Press D.

Alarm Mode

Timekeeping

Use the Timekeeping Mode to set and view the current time and date.

• Pressing A while in the Timekeeping Mode will cycle through the

Timekeeping Mode display formats as shown below.

Day of week

Day

Day of the Week/Day Screen

PM indicator

Hour : Minute

Second

Year

Month – Day

Date Screen

Barometric Pressure

Graph Screen

Day

Barometric
pressure
graph

Press A.

Read This Before You Set the Time and Date!
This watch is preset with a number of city codes, each of which represents
the time zone where that city is located. When setting the time, it is important
that you first select the correct city code for your Home City (the city where
you normally use the watch). If your location is not included in the preset city
codes, select the preset city code that is in the same time zone as your
location.

• Note that all of the times for the World Time Mode city codes are displayed

in accordance with the time and date settings you configure in the
Timekeeping Mode.

0.614161s