Casio Casio Watch 1852 User's Manual

Casio Watches User's Manual - Casio Watch 1852.
Download
Page  of 2
4.4, 1610 votes
background image

G’MIX(D)-1

A

C

D

B

E

GENERAL GUIDE

• The configuration of this watch may differ somewhat from that shown in the illustration.
• Press C to change from mode to mode.
• In any mode, press D to illuminate the display for about two seconds.
• The animated figures perform a variety of different actions, depending on the mode the watch is in.

Timekeeping Mode

Alarm Mode

Stopwatch Mode

A

C

D

B

E

TIMEKEEPING MODE

• Use E to switch the display between month/date

and date/day of the week.

• Press B to play a melody for about 10 seconds.

Pressing any key while a melody is play stops the
melody. The melody that plays depends on when
you press B.

Date

PM
indicator

Hour

Minutes

Seconds

Day of the week

To set the time and date
1. Hold down A while in the Timekeeping Mode. The seconds digits flash on the

display because they are 

selected.

2. Press C to change the selection in the following sequence.

A

C

D

B

E

Alarm on
indicator

Hourly time
signal on
indicator

Cur-
rent
time

Mode indicator

Hour

Minutes

To set the alarm time
1. Hold down A while in the Alarm Mode. The hour digits flash on the display be-

cause they are 

selected.

• At this time the Daily Alarm is switched on automatically.
2. Press C to change the selection in the following sequence.

3. Press E to increase the selected digits and B to decrease them. Holding down

either button changes the selection at high speed.

• The format (12-hour and 24-hour) of the alarm time matches the format you select

for normal timekeeping.

• When setting the alarm time using the 12-hour format, take care to set the time

correctly as morning or afternoon.

4. After you set the alarm time, press A to return to the Alarm Mode.
• If you do not operate any button for a few minutes while a selection is flashing, the

flashing stops and the watch goes back to the Alarm Mode automatically.

• If you do not operate any button for a few minutes in the Alarm Mode, the watch

goes back to the Timekeeping Mode automatically.

To switch the Daily Alarm and Hourly Time Signal on and off
Press E while in the Alarm Mode to change the status of the Daily Alarm and Hourly
Time Signal in the following sequence.

ALM : Daily Alarm
SIG : Hourly Time Signal

To test the Alarm
Pressing B sounds the currently selected alarm sound.
It takes about 10 seconds for the alarm sound to finish. You can stop it manually by
pressing any key.
• Note that if 0 is set as the alarm sound, pressing B randomly selects one of the

melodies. The sound that is randomly selected when the next alarm time is reached
will probably be different from the one that sounds when you press B.

STOPWATCH MODE

The Stopwatch Mode lets you measure elapsed time,
split times, and two finishes. The range of the stop-
watch is 23 hours, 59 minutes, 59.99 seconds.
• Animated figures appear on the display while the

stopwatch is measuring an elapsed time.

• If you do not perform any key operation while in

the Stopwatch Mode, the watch automatically re-
turns to the Timekeeping Mode (except when an
elapsed time measurement is in progress.

To measure elapsed time

1.Press E to start the stopwatch.
2.Press E to stop the stopwatch.

• You can resume the measurement operation by

pressing E again.

3.Press  B to clear the stopwatch to all zeros

(0H00’00”00).

To record split times
1. Press E to start the stopwatch.
2. Press B to display the timing up to that point. Stopwatch timing continues internal-

ly.

3. Press B to clear the split time and to continue time measurement on the display.
• You can repeat steps 2 and 3 as many times as you want.
4. Press E to stop the time measurement.
5. Press B to clear the stopwatch to all zeros.

To time first and second place finishes
1. Press E to start the stopwatch.
2. Press B when the first finisher crosses the line, and record the time.
3. Press E when the seconds finisher corsses the line.
4. Press B to display the finishing time of the second finisher.
5. Press B to clear the stopwatch to all zeros.

A

C

D

B

E

Hours

Mode indicator

Minutes

Seconds

1/100 seocnds

1623 1667 1668 1678 1807 1808
1809 1852 1853 1854 1855 1891

3. While the seconds digits are selected (flashing), press E to reset the seconds to

“00”. If you press E while the seconds count is in the range of 30 to 59, it is reset to
“00” and 1 is added to the minutes. If the seconds count is in the range of 00 to 29,
the minutes count is unchanged.

4. While any other digits (besides seconds), are selected (flashing), press E to in-

crease the number or B to decrease it. Holding down either button changes the
current selection at high speed.

• While the day of the week is selected, pressing E advances to the next day, while

pressing B returns to the previous day.

• While the 12/24-hour setting is selected, press E to switch between the two for-

mats.

5. After you set the time and date, press A to return to the Timekeeping Mode.
• The date can be set within the range of January 1, 1995 to December 31, 2039.
• If you do not operate any button for a few minutes while a selection is flashing, the

flashing stops and the watch goes back to the Timekeeping Mode automatically.

ABOUT THE BACKLIGHT

• Pressing D at any time illuminates the display for about two seconds and causes

an animated figure to appear. The type of animation that appears depends upon
when you press D.

• The backlight of this watch employs an electro-luminescent (EL) light, which loses

its illuminating power after very long term use.

• The watch will emit an audible sound whenever the display is illuminated. This is

caused by a transistor that vibrates when the EL panel lights up. It does not indicate
malfunction of the watch.

ALARM MODE

This watch include three built-in melodies, which you
can use in any of the following five settings to sound
when an alarm time is reached.

• See the MELODY LIST at the back of this manual for the names of melodies.
• When the Daily Alarm is switched on, the alarm sounds for about 20 seconds at the

preset time each day. Press any button to stop the alarm after it starts to sound.
When the Hourly Time Signal is switched on, the watch beeps every hour on the
hour.

Seconds

Hour

Minutes

Year

12/24-Hour

Format

Date

Month

Day of

the week

Hour

Minutes

Alarm Sound

Both OFF

Daily Alarm

Hourly Time

Both ON

only

Signal only

Setting

Alarm Sound

0.

Random play of melodies 1, 2, and 3

1.

Melody 1

2.

Melody 2

3.

Melody 3

4.

Beeper

0.586546s