Brother PC-7500 Owner's Manual

Brother Printers Owner's Manual - PC-7500.
Download
Page  of 2
4.9, 1263 votes
background image

11.5mm
(0.45inch)

1

2

1

1

2

1

Prepare a specially designed bobbin.
Préparez une canette appropriée.
Bereiten Sie eine für diese Maschine geeignete Unterfadenspule vor.
Bereid een speciaal ontworpen spoel voor.
Prepare una bobina especialmente diseñada.
Preparare una spolina speciale.

Insert the bobbin into the shuttle, pass the thread through the slot.   

● Be sure to insert the bobbin correctly.

Insérez la canette dans la navette et faites passer le fil dans la fente.   

● Veillez à insérer correctement la canette.

Legen Sie die Spule in die Kapsel hinein und führen Sie den Faden durch den Schlitz.   

● Achten Sie auf den richtigen Sitz der Spule.

Plaats de spoel in het spoelhuis en leid de draad door de gleuf.   

● Zorg ervoor dat de spoel op de juiste wijze geplaatst is.

Inserte la bobina en la lanzadera y pase el hilo por la ranura.   

● Asegúrese de que la bobina esté colocada correctamente.

Inserire la spolina nella navetta e far passare il filo attraverso la scanalatura.   

● Assicurarsi di inserire la spolina correttamente.

c

While pulling the thread to the left of the needle plate, move the bobbin cover to its original position.
Tout en tirant le fil vers la gauche de la plaque à aiguille, remettez le couvercle du compartiment à canette dans sa position d'origine.
Ziehen Sie den Faden zur linken Seite der Stichplatte und schieben Sie dabei die Spulenfachabdeckung in ihre ursprüngliche Position zurück.
Trek de naald naar de linkerkant van de naaldplaat en plaats het spoelhuisdeksel in de oorspronkelijke stand.
Mientras tira del hilo hacia la izquierda de la placa de la aguja, coloque la tapa de la bobina en su posición original.
Tirando il filo a sinistra della piastra dell’ago, ricollocare lo sportello della spolina nella posizione originale.

d

Trim the excess thread above the bobbin. 
Coupez le surplus de fil au-dessus de la canette.
Schneiden Sie den überschüssigen Faden über der Spule ab.
Knip de overtollige draad boven de spoel af.
Recorte el hilo sobrante de la bobina.
Tagliare il filo in eccesso dalla spolina.

8

Step down on the foot controller.

Appuyez sur la pédale de rhéostat.

Treten Sie auf den Fußanlasser.

Trap het voetpedaal in.

Pise el pedal.

Premere il reostato a pedale.

9

After the bobbin has stopped spinning, take your foot off of the foot controller.
Une fois que la canette s'arrête de tourner, enlevez votre pied de la pédale de rhéostat.
Nehmen Sie den Fuß vom Fußanlasser, wenn sich die Spule nicht mehr dreht.
Wanneer de spoel niet meer draait, neemt u uw voet van het voetpedaal.
Cuando la bobina haya terminado de enrollarse, deje de pisar el pedal.
Quando la spolina ha cessato di girare su se stessa sollevare il piede dal reostato a pedale.

0

Cut the thread, slide the bobbin winder shaft to the left, and then remove the bobbin.
Coupez le fil, faites glisser l’axe du bobineur de canette vers la gauche, puis retirez la canette.
Schneiden Sie den Faden ab, schieben Sie den Spuler nach links und entfernen Sie die volle Spule vom Spuler.
Snij de draad door, schuif de spoelopwindas naar links en verwijderd de spoel.
Corte el hilo, desplace la clavija de la devanadora hacia la izquierda y retire la bobina.
Tagliare il filo, spingere l’albero avvolgitore spolina verso sinistra, quindi togliere la spolina.

a

Open the bobbin cover 1.
Ouvrez le couvercle du compartiment à canette 1.
Öffnen Sie die Spulenfachabdeckung 1.
Open het spoelhuisdeksel 1.
Abra la tapa de la bobina 1.
Aprire lo sportello della spolina 1.

b

Wind the thread around the bobbin a few times, then take your foot off of the foot controller.
Enroulez plusieurs fois le fil autour de la canette, puis enlevez votre pied de la pédale de rhéostat.
Wickeln Sie den Faden ein paar mal auf die Spule und nehmen Sie dann den Fuß vom Fußanlasser.
Wind de draad enkele malen rond de spoel en neem uw voet van het voetpedaal.
Enrolle el hilo alrededor de la bobina unas cuantas veces y después deje de pisar el pedal.
Avvolgere per alcune volte il filo intorno alla spolina e sollevare quindi il piede dal reostato a pedale.

7

1

See reverse.
Voir au verso.
Siehe Rückseite.
Zie ommezijde.
Ver al dorso.
Vedere fermatura.

XC5077-0211

Quick Reference Chart 1  – Preparing the bobbin thread – / Tableau de référence rapide 1  – Préparation du fil de la canette – / Kurzübersicht 1  – Vorbereitung des Spulenfadens –
Verkorte handleiding 1  – De onderdraad voorbereiden – / Tabla de referencia rápida 1  – Preparación del hilo de la bobina – / Tabella di riferimento rapido 1  – Preparazione della spolina –

Be sure to first read the “IMPORTANT SAFETY INSTRUCTIONS” in the Operation Manual. This Quick Reference Chart provides information on winding and installing the bobbin. For each step in the procedure, refer to the illustration of the sewing machine in the center for an indication of the exact location of the operation. For details on the procedure, refer to “Winding the Bobbin”, “Lower Threading” in the Operation Manual.

Lisez attentivement les “INSTRUCTIONS DE SÉCURITÉ IMPORTANTES” du manuel d’instructions. Ce tableau de référence rapide donne des informations sur le bobinage et l’installation de la canette. A chaque étape de la procédure, reportez-vous à l’illustration de la machine à coudre, se trouvant au centre, pour une indication de l’emplacement exact de l’opération. Pour obtenir des détails sur la procédure, reportez-vous à la section “Bobinage de la canette”, “Enfilage du fil de dessous” du manuel d’instructions.

Lesen Sie in jedem Fall zunächst die “WICHTIGE SICHERHEITSANWEISUNGEN” in der Bedienungsanleitung. Diese Kurzübersicht enhält Informationen zum Aufspulen und Einsetzen der Unterfadenspule. Beachten Sie bei jedem Bedienungsschritt die Abbildungen der Nähmaschine in der Mitte, aus denen der genaue Ort der Bedienungsvorgänge zu ersehen ist. Für Einzelheiten zur Bedienung lesen Sie bitte den Abschnitt über das “Aufspulen des Unterfadens”, “Einfädeln des Unterfadens” in der Bedienungsanleitung.

Zorg ervoor dat u eerst de “BELANGRIJKE VEILIGHEIDSINSTRUCTIES” in de handleiding hebt gelezen. In deze Verkorte handleiding vindt u informatie over het opwinden en het plaatsen van de spoel. Voor elke stap in de procedure raadpleegt u de afbeelding van de naaimachine in het midden voor een verwijzing naar de exacte locatie van de handeling. Voor details over de procedure raadpleegt u “De spoel opwinden”, “De onderdraad inrijgen” in de handleiding.

Lea primero las “INSTRUCCIONES IMPORTANTES DE SEGURIDAD” del Manual de Instrucciones. Esta tabla de referencia rápida proporciona información acerca del devanado y la instalación de la bobina. Para cada fase del procedimiento, fíjese en la ilustración de la máquina de coser que se encuentra en el centro para saber exactamente dónde se sitúa la operación. Para más detalles sobre el procedimiento, consulte el apartado “Devanado de la bobina”, “Enhebrado del hilo inferior” en el Manual de Instrucciones.

Leggere dapprima le “ISTRUZIONI DI SICUREZZA IMPORTANTI” del manuale d’istruzione. La presente tabella di rapida consultazione riporta le informazioni sull’avvolgimento e il montaggio della spolina. Per ogni passo della procedura, fare riferimento alla figura della macchina da cucire al centro per stabilire così l’esatta posizione dell’operazione. Per informazioni dettagliate sulla procedura, consultare “Avvolgimento della spolina”, “Infilatura inferiore” del manuale d’istruzione.

Actual size
Taille réelle

Tatsächliche Größe

Ware grootte

Tamaño real

Dimensioni attuali

2

4

8 a

3

b

d

Align the spring 1 with the groove 2 and place the bobbin onto the bobbin winder shaft, and then slide the bobbin winder shaft to the right.
Alignez le ressort 1 sur la rainure 2 et placez la canette sur l'axe du dévidoir, puis faites glisser l'axe vers la droite.
Richten Sie die Feder 1 mit der Kerbe 2 aus, setzen die Spule auf die Spulenwelle und schieben dann die Spulenwelle nach rechts.
Houd de veer 1 op één lijn met de groef 2, plaats de spoel op de spoelwinderas en schuif vervolgens de spoelwinderas naar rechts.
Alinee el resorte 1 con la ranura 2 y coloque la bobina en la devanadora y, a continuación, mueva ésta hacia la derecha.
Allineare la molla 1 con la scanalatura 2 e porre la spolina sul relativo albero del dispositivo di avvolgimento spostando poi quest’ultimo verso destra. 

Pull up the spool pin and place a spool of thread on this pin.
Tirez sur le porte-bobine pour le faire sortir et placez une bobine de fil.
Ziehen Sie den Garnrollenstift heraus und setzen Sie eine Garnrolle auf diesen Stift.
Trek de klospen omhoog en plaats een klos garen op deze pen.
Tire del eje del carrete y coloque un carrete de hilo.
Estrarre il portarocchetto e inserirvi un rocchetto di filo.

Pass the thread around the bobbin winding tension disk 1.
Faites passer le fil autour du disque de tension de bobinage de la canette 1.
Führen Sie den Faden um die Fadenspannrolle 1.
Leid de draad rond de schijf voor de spoelwinderspanning 1.
Pase el hilo alrededor del disco de tensión de devanado de la bobina 1.
Far passare il filo intorno al disco tenditore per l’avvolgimento della spolina 1.

Pass the thread through the hole on the bobbin from the inside.
Faites passer le fil par l'orifice de la canette depuis l'intérieur.
Führen Sie den Faden von innen durch das Loch in der Spule.
Leid de draad van binnen uit door het gat in de spoel.
Pase el hilo por el orificio de la bobina desde el interior.
Inserire il filo dall’interno attraverso il foro della spolina.

While holding the end of the thread, gently depress the foot controller.
Tout en tenant l'extrémité du fil, appuyez légèrement sur la pédale du rhéostat.
Halten Sie das Ende des Fadens und drücken Sie vorsichtig den Fußanlasser.
Houd het uiteinde van de draad vast en trap het voetpedaal licht in.
Mientras sujeta el extremo del hilo, pise suavemente el pedal.
Tenendo l’estremità del filo, rilasciare delicatamente il reostato a pedale.

5

1

2

3

4

6

Turn on the Main power/sewing light switch.
Activez l'interrupteur principal/de la lampe.
Drücken Sie den Netz-/Nählichtschalter.
Zet de aan/uitschakelaar aan.
Encienda el interruptor principal y de luz de cosido.
Accendere l’interruttore principale e la luce dell’area di lavoro.

0.546453s