Bose Acoustimass 10 Series IV system Owner's Manual | Page 10

Bose Audio Owner's Manual - Acoustimass 10 Series IV system.
Download
Page  of 44
4.8, 2105 votes
background image

10

SETTING UP

English

Français

Español

Figure 8

Acoustimass

® module to 

receiver connections

Thumbscrews

Home theater 

receivers

Acoustimass

®

module

LFE connector with 

cover removed

Checking the connections

Before plugging in the Acoustimass module, check all connections from the receiver to the 
the module and the module to the small speakers (Figure 8).

• Make sure all cube speaker arrays are connected to the proper terminals according to their 

position in your room. 

• Check to be sure all wires are connected to your surround receiver with the proper polarity 

(+ to + and – to – wires). Incorrect wiring can result in a total loss of module output. 

• Correct any wiring problems before you plug in your receiver and turn it on. 

When all the connections check out, plug the power cord from the Acoustimass module into 
an AC (mains) outlet. Plug in the receiver also.

Note: Bose recommends using a quality surge suppressor on all electronics equipment. 
Voltage variations and spikes can damage electronic components in any system. Using a high- 
quality suppressor (available at electronics stores) can eliminate the vast majority of failures 
caused by a power surge.

Also See for Bose Acoustimass 10 Series IV system

0.479099s