Bosch SHSM63W52N Instruction Manual | Page 28

300 Series 24" Scoop Handle Dishwasher SHSM63W52N White
Download
Page  of 88
4.6, 2086 votes
background image

en-us   Operating the Dishwasher

28

Switching off the appliance

Short time after the end of the wash 

cycle:

1. Open the door.

2. Switch off On/Off button (.

3. Turn off water supply.

4. Remove the utensils when they 

have cooled down.

9

WARNING
RISK OF INJURY!

To avoid risk of injury, always 

use caution when opening the 

door during or following a wash 

cycle as hot water or steam 

may escape. Do not fully open 

the door until water noises have 

stopped and steam has 

subsided.

Interrupting the wash cycle

9

CAUTION
Expansion (overpressure) may 

cause the appliance door to 

open and/or water to escape! If 

the door was opened on an 

appliance which has a hot water 

connection or is heated, always 

leave the door ajar for several 

minutes and then close.

1. Open the door.

2. Switch off On/Off switch (.

The LED’s go out. The wash cycle 

is saved.

3. To continue the wash cycle, 

switch on the On/Off switch ( 

again.

4. Close the door.

Note: Your dishwasher is protected 

against unintentional operation. If the 

appliance door remains open for 

more than 4 seconds after pressing 

the Start button, the operation will be 

paused. Press the Start button again 

and close the appliance door.

Terminating the wash cycle 

(Reset)

Terminati

ng the wa

sh cyle

1. Press and hold Start button P 

for approximately 3 seconds until 

the display reads ‹:‹‚.

2. Wait about 1 minute while the 

dishwasher drains.

3. Press On/Off button (.

You may now power the dishwasher 

back on and begin a new cycle if 

desired.

Changing the wash cycle
When the Start button ( has been 

pressed, the wash cycle cannot be 

changed. The only way a wash cycle 

can be changed is by terminating the 

wash cycle (Reset).

InfoLight®
While the wash cycle is running, a 

light spot shines on the floor under 

the appliance door.  

Do not open the appliance door until 

the light point is no longer visible on 

the floor.  

If the appliance door is not 

completely closed, the light spot 

flashes*.  

If the appliance is installed at 

eye-level, with flush furniture front, the 

light point is not visible. 

In darkened rooms, some light 

scattering may be visible. This is 

normal and cannot be changed.
You can switch the Infolight on or off.

‚:‹‹

Off

‚:‹‚

low

0.597890s