Bosch SGE53X56UC Installation Instructions | Page 7

300 Series 24" Recessed Handle Special Application
Download
Page  of 28
4.6, 2180 votes
background image

Enclosure Requirements 

WARNING 

Avoid Scalding or Electrical Shock Hazard! 

Make sure the water supply and electrical supply are 

shut off before installation or service. 

NOTE: This dishwasher is designed to be enclosed on 
the top and both sides by standard residential kitchen 
cabinetry. 
Select a location as close to the sink as possible for 
easy access to water supply and drain lines.  
For proper dishwasher operation and appearance, 
ensure that the enclosure is square and has the 
dimensions shown in Figure 1

Figure 1 

NOTE: If your dishwasher opening width measures 
>235/8Ǝ (600 mm) use the TOP or SIDE MOUNT

mounting methods.
If your dishwasher opening width measures 235/8Ǝ

(600 mm) use the ALTERNATE SIDE MOUNT
mounting method.
If the dishwasher is to be installed in a corner, make 
sure that there is adequate clearance to open the 
door. See Figure 2

Figure 2 

WARNING 

Avoid Electrical Shock/Fire Hazard! 

Do not allow the electrical and water supply lines 

to touch. 

After locating the proper place for your new 
dishwasher, you wil  need to create any required 
openings to allow for passage of the water, drain and 
electrical line. In order to avoid interference with the 
dishwasher when sliding it into the cabinet, place your 
openings within the dimensions shown in Figure 3

Figure 3 

Required Openings: 
43/4Ǝ x 2

3/8Ǝ (120 x 60 mm) - To pass the included 

electrical supply junction box through to adjacent 
cabinet. 
Note: If the incoming electric supply, water supply and 
drain connections are all in the same cabinet, the one 
43/4Ǝ x 2

3/8Ǝ (120 x 60 mm) hole will be large enough 

for al  three to pass through. 
4Ǝ x 2Ǝ (100 x 50 mm) - To pass the included water 

supply line toward the water supply. 
11/4Ǝ (32 mm) diameter - To pass the dishwasher drain 

hose toward the drain connection. 
Before sliding the dishwasher into the cabinet, remove 
the hose clip at the back of the dishwasher as shown 
in Figure 4. The hose clip may be used later to hold 
the drain hose as shown in Figure 10

Figure 4 

In select models, remove the rubber apron on top of 
the dishwasher and set aside for later use (Figure 5)

Figure 5 

0.585409s