Bosch NGM8656UC Installation Instructions | Page 6

Bosch Gas Cooktop Installation Instructions - NGM8656UC.
Download
Page  of 40
4.8, 2205 votes
background image

6

Installation Procedure

Installation Prcedu

This conversion process adjusts the flow of gas to the 

burners to accommodate an LP gas fuel source.

9

CAUTION

TURN OFF GAS AND ELECTRICITY
Perform the following:
▯ shut off the gas valve for the gas supply line to

the cooktop

▯ remove the cooktop power cord from the

electrical outlet or turn off the breaker at the

breaker box.

▯ turn all control knobs to the “Off” position.

Checklist 
Each of the following steps must be completed 

correctly for the appliance to function properly.
Check off each step as it is finished.

Step 1 - Convert the pressure regulator
Locate the pressure regulator on the bottom right end of 

the cooktop.
Note:  The arrow on the back of the regulator must point 

in the direction of the gas flow to the cooktop.

1. Remove the hexagon shaped cap from the regulator

making sure not to dislodge the gasket on the cap or

the spring inside the regulator.

2. Grasp the plastic button stem firmly and pull it

forcefully from the metal cap. The stem snaps snugly

into an indent in the cap and may require a strong pull

to remove. (Hint: it may be helpful to gently “rock” the

plastic stem while pulling it from the metal cap.)

3. After removing the stem from the cap, rotate the stem

180° so the button end of the stem is away from the

cap and the letters “LP” on the stem are upside down

when the cap is set flat on its head. Snap the stem

back in place in this position inserting it into the indent

in the metal cap.The stem should snap into place.

4.

Important: Attach the metallic sticker (included with

this conversion kit) to the bottom of the appliance as

shown, placing it near the appliance data plate (shows

model number and information about the appliance).

This sticker provides notice that the appliance has

been converted for use with LP gas.

Ù Step 1 Convert the pressure regulator to use 

LP gas.

Ù Step 2 Remove the grates, burner caps and 

burners. Remove the Natural Gas (NG) 

orifices and replace them with the LP gas 

orifices supplied with this kit. See Before 

You Begin chapter on previous page for 

correct placement of orifice by model 

number.

Ù Step 3 Replace the burners, burner caps and

grates.

Ù Step 4 Adjust the unit valves to LP settings.

A

Spring

B

Plastic button stem

C

Gasket

$

&

%

$

%

81,7&219(57(')2586(:,7+/3*$6

0$1,)2/'35(6685($7ƒ:&

$33$5(,/&219(57,328587,/,6$7,21$9(&*$=/3

35(66,21'(SR&($8',675,%87(85

81,'$'&219(57,'$'$3(752/,2/,&8)(&+2

&2/801$',675,%8,'25$'(35(6,21'($*8$$´

Related Manuals for Bosch NGM8656UC

0.582877s