Bosch HBL87M52UC Installation Instructions | Page 8

Bosch Combination Ovens Installation Instructions - HBL87M52UC.
Download
Page  of 56
4.1, 1565 votes
background image

8

Removing Packaging

1. Cut straps on the outside of the boxes.
2. Remove the upper boxed unit of the combination oven

and place on floor so that both shipping cartons can

be opened.

3. Perform the following steps on both units of the

combination oven.

Remove the cardboard box by lifting it up and off

the unit

Remove all top and side cardboard and foam

braces.

Place the unit (leaving it on the shipping base) in

front of the cabinet where it is to be installed.

Remove all accessories, racks, packing materials

and literature from the oven cavities.

Unscrew unit from packaging brackets as shown in

“Packaging Bracket Removal-Left and Right Sides”.

Notes

The screws near the base mounting bracket of each

unit are all Star-head (T-20 size). Only the one screw

that goes through the slotted hole in the mounting

bracket on the left and right sides of the unit needs

to be removed in order to lift the unit from the

mounting base. The screw circled in the image

below and marked as (A) is the screw that needs to

be removed.

Remove one screw only from each bracket. This will

release the oven from the shipping base. Do not

remove any additional screws from the oven.

Packaging Bracket Removal-Left and 

Right Sides

Note:  Actual bracket varies in appearance. The bracket 

remains in the packaging base. The unit should stay on 

the packaging base until ready to be lifted into cabinet 

cutout or onto the lower oven.

Preparing Ovens
Place ovens in front of the cabinet where it is to be 

installed so that they are in line with the cabinet cutout.

Check to be sure all packing materials have been 

removed from the unit. Also remove the accessories, 

oven racks, literature pack and any shipping materials 

from inside the oven cavity. Check both ovens for a 

double oven or combination oven installation.

Installation

Pre-Assembly of the Combination Oven
Combination ovens require the two components to be 

assembled prior to installing the combination unit into the 

wall cabinet.

Note:  The installation procedures differ between the 

microwave, speed oven and steam convection oven 

combination units. The parts contained in the square 

tube parts box are common to all three installations.

Parts Provided
Parts Provided

Universal connector 

bracket (2)--in parts box 

on top of oven

Screws (16)--in red bag 

inside parts box on top of 

oven.

0.614892s