Bosch HBL57M52UC Installation Instructions | Page 6

Bosch Combination Ovens Installation Instructions - HBL57M52UC.
Download
Page  of 56
4.1, 1366 votes
background image

6

Checklist
Use this checklist to verify that you have completed each 

step of the installation process. This can help you avoid 

mistakes.

Before installing the oven, be sure to verify the cabinet

dimensions are correct and the required electrical

connections are present.

Refer to additional information in this manual

regarding Safety, Cabinet Dimensions, Removing

Packaging, Electrical Installation, Testing the

Installation and Customer Service.

Remove the lower oven door to reduce the unit weight

and to provide access to gripping points for lifting. See

“Remove Lower Oven Door Prior to Installation”

information.

Move the oven units into place in front of the cabinet

opening, leaving the bottom packaging on the units to

avoid damaging flooring.

Remove the Star-head screws (T-20 size using Star-

head screwdriver) holding the speed microwave oven

or steam convection oven to the base of its carton.

Assemble the two units of the combination oven. See

“Pre-Assembly of the Combination Oven”.

Connect the power cable from the lower oven to the

junction box in the cabinet.

Remove the Star-head screws (T-20 size using Star-

head screwdriver) holding the lower oven to the base

of its carton.

Team-lift the unit directly into the cabinet cutout taking

care not to pinch fingers, scratch arms or hands.

Slide the unit all the way in to place.

Fasten the combination unit to the cabinetry opening

with the screws supplied (using Philips screwdriver).

Reinstall the oven door removed in Step 3 above.

Consult the complete installation instructions and

follow the remainder of the procedures listed,

including performing operation test.

INSTALLER- Leave the literature pack and the

accessories with the customer.

Cabinet Dimension Requirements

It is good practice, when an oven is installed at the end 

of a cabinet run, adjacent to a perpendicular wall, or 

cabinet door, to allow at least 1/4” (6.4 mm) space 

between the side of the oven and the wall/door.

For oven support, install 2x4s extending front to back 

flush with the bottom and the sides of the opening. The 

supporting base must be well secured to the floor/

cabinet and level.

Junction boxes can be located anywhere within reach of 

the oven’s power cable.

The cabinet base must be flat and capable of supporting 

the weight of the combination oven up to 429 lbs. (195 

kg).

0.643233s