Bosch 800 Series24" Recessed Handle Dishwasher with Home Connect Installation Instructions | Page 7

7

After locating the proper place for your new dishwasher, 

you will need to create any required openings to allow for 

passage of the water, drain and electrical line. In order to 

avoid interference with the dishwasher when sliding it into the 

cabinet, place your openings within the dimensions shown 

in 

Figure 3 below.

Required Openings:

43/4″ x 23/8″ (120 x 60  mm) - To pass the included electrical supply 

junction box through to adjacent cabinet. 

Note: If the incoming electric supply, water supply and drain 

connections are all in the same cabinet, the one 43/4″ x 23/8″ 
(120 x 60 mm)

 hole will be large enough for all three to pass 

through.

4″ x 2″ (100 x 50 mm) - To pass the included water supply line 

toward the water supply

11/4″ (32 mm) diameter - To pass the dishwasher drain hose 

toward the drain connection

Check clearance 

between 

dishwasher door 

and wall

Countertop

23

5

/8 - 24

1

/4″ (600 - 616  mm)

Before sliding the dishwasher into the cabinet, remove the 

hose clip at the back of the dishwasher as shown in 

Figure 

4. The hose clip may be used later to hold the drain hose as 

shown in 

Figure 10. 

In select models, remove the rubber apron on top of the 

dishwasher and set aside for later use. See 

Figure 5. 

Figure 2

Enclosure Requirements

NOTE: This dishwasher is designed to be enclosed on the 

top and both sides by standard residential kitchen cabinetry. 
Select a location as close to the sink as possible for easy 

access to water supply and drain lines. 

For proper dishwasher operation and appearance, ensure 

that the enclosure is square and has the dimensions shown 

in 

Figure 1 below.

NOTE: If your dishwasher opening width measures 

>235/8″ (600mm) use the TOP or SIDE MOUNT mounting 

methods.

If your dishwasher opening width measures 235/8″(600mm) 

use the ALTERNATE SIDE MOUNT mounting method.

If the dishwasher is to be installed in a corner, make sure that 

there is adequate clearance to open the door. See 

Figure 

2 below.

WARNING

Avoid Scalding or Electrical Shock Hazard!

Make sure the water supply and electrical supply 

are shut off before installation or service.

Avoid Electrical Shock/Fire Hazard

Do not allow the electrical and water supply lines 

to touch.  

WARNING

90°

225/

8

″ (575 mm)

34¼

″(867 mm)

Figure 1

Figure 3

Figure 4

Figure 5

41/2"

(114mm)

21/2"

(64mm)

7