Bosch 300 Series24" Recessed Handle Special Application Installation Instructions | Page 9

Bosch Compact Washers Installation Instructions - 300 Series24" Recessed Handle Special Application.
Download
Page  of 28
4.6, 1593 votes
background image

Method B - To permanently connect to household 
or field wiring 
1. Remove the dishwasher electrical supply junction

box cover and connect to the power supply cord 
from the house installation (see Figure 7). 

2. Remove 2Ǝ to 3Ǝ (51 – 76 mm) of the outer

casing of the household or field supply wiring as
shown in Figure 8. Remove 3/8Ǝ to 1/2Ǝ (10 – 13

mm) of the insulation from each wire as shown in
Figure 8.

Figure 8 

3. Insert the bare copper or green wire(ground) to

the “G” ground connection “

” of the terminal

block and securely tighten the terminal block
screw (see Figure 7).

4. Insert the white (neutral) wire to the “N”

connection of the terminal block and securely
tighten the terminal block screw.

5. Insert the black (hot) wire to the “L” connection of

the terminal block and securely tighten the
terminal block screw.

6. Check all electrical connections to make sure

they are secure and then attach the junction box
cover with the 4 screws.

WARNING 

Avoid Electrical Shock Hazard! 

To avoid possible injury or property damage, care 

should be exercised when the dishwasher is installed 

or removed to reduce the likelihood of damage to the 

power cord. 

Inlet Water Connections 

Hot Water Supply 
The hot water heater should be set to deliver 
approximately 120° F (49° C) water to the 
dishwasher. Water that is too hot can cause some 
detergents to lose effectiveness. Lower water 
temperatures will increase run times. The hot water 
supply pressure must be between 15 - 145 psi (1 - 
10 bar). 

IMPORTANT NOTES: 
x If using a solder joint instead of a compression 

fitting, be sure to make all solder connections 
before connecting the water supply line to the 
dishwasher. 

x Make sure there are no sharp bends or kinks in 

the water line that might restrict water flow. 

x Always use the appropriate seal when making 

plumbing connections. 

x Before connecting the water supply line to the 

dishwasher, flush the incoming water line for 
approximately 5 minutes to clear any foreign 
material. 

x Turn on the water supply and check for leaks 

after connections are made. 

WARNING 

Avoid Scald Hazard! 

Do not perform any work on a charged hot water line. 

Serious injury could result. Only qualified plumbers 

should perform plumbing work. Do not attempt any work 

on the dishwasher hot water supply plumbing until you 

are certain the hot water supply is shut off. 

CAUTION 

Temperatures required for soldering and sweating will 

damage the dishwasher. If plumbing lines are to be 

soldered or sweated, keep the heat source at least 6 

inches (152.4 mm) away from the dishwasher. 

Water Supply Shut Off Valve 
Install an easily accessible shut-off valve (not 
supplied) in the hot water supply line, as shown in 
Figure 9. All solder connections must be made 
before the water line is connected to the 
dishwasher. 

Related Manuals for Bosch 300 Series24" Recessed Handle Special Application

0.592320s