Bosch 100 Series24" Bar Handle 100 Series Instruction Manual | Page 33

Bosch Dishwasher Instruction Manual - 100 Series24" Bar Handle 100 Series.
Download
Page  of 100
4.7, 1546 votes
background image

Operating the Dishwasher   en-us

33

Terminating the wash cycle 

(Reset)

Terminating the wash cycle

1. Press and hold Start button P 

for approximately 3 seconds until 

the display reads ‹:‹‚.

2. Wait about 1 minute while the 

dishwasher drains.

3. Press On/Off button (.

You may now power the dishwasher 

back on and begin a new cycle if 

desired.

Changing the wash cycle
When the Start button ( has been 

pressed, the wash cycle cannot be 

changed. The only way a wash cycle 

can be changed is by terminating the 

wash cycle (Reset).

InfoLight®
While the wash cycle is running, a 

light spot shines on the floor under 

the appliance door.  

Do not open the appliance door until 

the light point is no longer visible on 

the floor.  

If the appliance door is not 

completely closed, the light spot 

flashes*.  

If the appliance is installed at 

eye-level, with flush furniture front, the 

light point is not visible. 

In darkened rooms, some light 

scattering may be visible. This is 

normal and cannot be changed.
You can switch the Infolight on or off.

To change the setting:

1. Press the On/Off button (.

2. Hold down function key # and 

press Start button P until the 

display 8 indicates š:‹x (x can 

be any number). Release both 

buttons.

3. Press function key # until the 

display shows ‚:‹‚.

4. Press the function key 3 to 

switch the InfoLight® feature on 

‚:‹‚ or off ‚:‹‹.

5. Press Start button P to save 

the setting. 

Intensive drying
The final rinse uses a higher 

temperature which improves the 

drying result. The cycle time and 

energy usage may be increased. 

(Caution if utensils are delicate!)
This feature has two settings:

1. Press the On/Off button (.

2. Hold down function key # and 

press Start button P until the 

display 8 indicates •:x (x can 

be any number).

3. Release both buttons.

4. Press function key # until the 

display 8 indicates the factory 

set value š:‹‹.

5. Press function key 3 to switch 

the intensive drying feature on 

š:‹‚ or off š:‹‹.

6. Press Start button P to save 

setting.

‚:‹‹

Off

‚:‹‚

low

š:‹‹ Off

š:‹‚ On

0.653050s