Bosch 100 Series24" Bar Handle 100 Series Installation Instructions | Page 15

Bosch Dishwasher Installation Instructions - 100 Series24" Bar Handle 100 Series.
Download
Page  of 64
4.8, 2399 votes
background image

15

Place the assembled strain relief 

plate back into the junction box and 

re-attach the screw.  Make sure the 

tab on the right side of the strain 

relief plate is outside the junction 

box as you slide it into place.  

Do Not Over-tighten or
Remove Terminal Screws

14

Note: Do not loosen or remove 

terminal screws!  Damage may 

occur. Bend the wires so the 

exposed leads can reach the 

appropriate contacts. Insert the 

black (hot) wire into the left opening 

on the terminal strip marked “L”, the 

white (neutral) wire in the middle 

opening of the terminal strip marked 

“N”, and the bare copper or green 

(ground) wire into the right opening 

of the terminal strip marked “G”.  

Do Not Over-tighten or
Remove Terminal Screws

15

Make sure that the exposed 

(non-insulated) portion of each 

stripped wire shows above 

and below the terminal screw. 

Securely tighten the terminal 

screws, but do not 

over-tighten 

or damage may occur.

Hand tighten only. Do not use 

power tools.

16

0.603479s