Bosch 100 Series24" Bar Handle 100 Series Installation Instructions | Page 5
5
The customer has the responsibility of ensuring that the dishwasher
electrical installation is in compliance with all national and local electrical
codes and ordinances. The dishwasher is designed for an electrical supply
of 120 V, 60 Hz, AC, connected to a dishwasher-dedicated, properly
grounded electrical circuit with a fuse or breaker rated for 15 amps.
Electrical supply conductors shall be a minimum #14 AWG copper only
wire rated at 75°C (167°F) or higher.
This appliance must be connected to a grounded metal, permanent wiring
system, or an equipment-grounding conductor must be run with the circuit
conductors and connected to the equipment-grounding terminal or lead on
the appliance. Do not use extension cords.
Avoiding Plumbing/Scalding Hazards
Do not perform any work on a charged hot water line. Serious injury could
result. Only a qualified plumber should perform plumbing work. Do not
attempt any work on the dishwasher hot water supply plumbing until you
are certain the hot water supply is shut off.
Do not over tighten the 90° elbow. Doing so may damage the water inlet
valve and cause a water leak.
Check local plumbing codes for approved plumbing procedures and ac-
cessories. All plumbing should be done in accordance with national and
local codes.
These instructions depict an installation method for stainless steel braided
hose or PEX hot water supply lines. If using copper tubing or other material
for water supply, defer to a licensed plumber for proper installation.
Inspect the Dishwasher
After unpacking the dishwasher and prior to installation, thoroughly inspect
the dishwasher for possible freight or cosmetic damage. Report any
damage immediately. Cosmetic defects must be reported within 30 days
of installation.
NOTE: Do not discard any bags or items that come with the original package
until after the entire installation has been completed.
Also See for Bosch 100 Series24" Bar Handle 100 Series
- Bosch 100 Series24" Bar Handle 100 Series Instruction Manual 100 pages
- Bosch 100 Series24" Bar Handle 100 Series Installation Instructions 64 pages
- Bosch 100 Series24" Bar Handle 100 Series Instruction Manual 100 pages
- Bosch 100 Series24" Bar Handle 100 Series Instruction Manual 100 pages
- Bosch 100 Series24" Bar Handle 100 Series Installation Instructions 64 pages
Related Manuals for Bosch 100 Series24" Bar Handle 100 Series
-
Baumatic Dishwasher BDW45.1 User's Manual
48 pages
-
Bosch Dishwasher SMV50C00GB Instruction Manual
28 pages
-
Diplomat Dishwasher ADP8352 User's Manual
10 pages
-
Electrolux Dishwasher ESF 63020 User's Manual
40 pages
-
Electrolux Dishwasher Diva Service Manual
32 pages
-
Fisher & Paykel Dishwasher DishDrawer DD603 I Service Manual
47 pages
-
Miele Dishwasher G 646 SC Operation Manual
68 pages
-
NEFF Dishwasher S5443X2GB Operation Manual
27 pages
-
Technika Dishwasher TBD4SS-2 User's Manual
6 pages
-
Whirlpool Dishwasher Whirlpool Dishwasher ADP6000IX User's Manual
13 pages
-
Hotpoint Dishwasher EXPERIENCE DISHWASHER FDFET 33121 User's Manual
20 pages
-
Westinghouse Dishwasher WSF6602 User's Manual
24 pages
-
DEFY Dishwasher DDW 157 User's Manual
18 pages
-
Fisher & Paykel Dishwasher 918TD User's Manual
21 pages
-
Maytag Dishwasher MDB4949SDM Installation Guide
76 pages
-
Maytag Dishwasher MDB4949SDM Use & Care Manual
42 pages
-
Maytag Dishwasher MDB5969SDM Use & Care Manual
42 pages
-
Maytag Dishwasher MDB8969SDM Use & Care Manual
42 pages
-
Miele Dishwasher G 6165 SCVi Futura Crystal Operating and Installation Instructions
80 pages
-
Miele Dishwasher G 6165 SCVi Futura Crystal Specification Sheet
5 pages
-
Miele Dishwasher G 6365 SCVi Specification Sheet
5 pages
-
Miele Dishwasher G 6560 SCVi Specification Sheet
5 pages
-
Frigidaire Dishwasher FFBD2406NS Installation Instructions
2 pages
-
Meiko Dishwasher K-200 Owner's Manual
32 pages