Black & Decker CM047-SRVC-2 User's Manual

Black & Decker TV Cables User's Manual - CM047-SRVC-2.
Download
Page  of 1
4.9, 1132 votes
background image

CM047-SRVC-2 & CM047-SRVC    

Removable Air Vent Pedestal

CM047-SRVC-2

CM047-SRVC

 

Consumer Hotline: 
(USA)    (800) 841-0884
(INT'L)   (626) 254-9005
               Mon-Fri. 9am-5pm, PST

www.arkon.com

Arcadia, CA 91006 USA

Made in Taiwan

© Copyright 2007 Arkon Resources, Inc.

The Mobile Mounting Specialists

TM

Safety Precautions
Do not install Arkon products over an air bag cover or within the air 
bag deployment zone. Arkon Resources, Inc. assumes no responsi-
bility of liability for injury or death as a result of car crashes and/or 
air bag deployment.

Arkon Resources, Inc. is not responsible for any damages caused to 
your car, your device, or yourself due to the installation or use of the 
pedestal mount.

Flat side face up

Step 1.

Step 2.

Remove the device from the vent 
mount assembly.

Pinch the vent clips (A) so that the 
teeth open and carefully slide the 
pedestal from the vent/blade.  

Pedestal Removal

Step 1. Attach the vent mounting clips (A) to the back of the pedestal (B) 

with the vent clips positioned with the flat sides facing up. 

Pedestal Assembly

Step 1.

Pinch the vent mounting clips (A) so that the teeth open and 
gently insert vent pedestal into vent louvres until the mounting 
clips are attached to the fin/blade of the vent. Adjust the support 
leg (C) vertically until it rests firmly along the bottom of the vent 
or dash surface below the vent. 

Insertion of Pedestal into the Air Vent

(A)

(C)

 

(A)

(A)

(B)

(F)

(E)

(D)

(B)

Step 1.

Step 2.

Adjust the swivel angle of the pedestal head by f

irmly holding 

the back of the pedestal (B), pulling out the pedestal head and 
twisting to the desired angle. Adjust the lateral angle of the 
pedestal head (E) by simply twis

ting the head on the pivot axis 

(D). 

Use caution when adjusting the swivel movement to avoid 
damaging your air vents.

Attach the device cradle to the pedestal by inserting the dual T-
Tabs of the pedestal (E) into the T-slots of the cradle (F). (Cradle 
Sold Separately)

Use caution when removing the pedestal. Make sure that the 
teeth of the vent clips are open enough to not damage vent.

Pedestal Adjustment & Device Cradle Installation 
(Cradle Sold Separately)

 

0.521089s