Biostar A58ML Owner's Manual | Page 3

Biostar Motherboards Owner's Manual - A58ML.
Download
Page  of 49
4.6, 1382 votes
background image

 A58MD/A58MG/A58ML 

CHAPTER 1: INTRODUCTION 

1.1  Before You Start 

Thank you for choosing our product. Before you start installing the 
motherboard, please make sure you follow the instructions below: 

„

  Prepare a dry and stable working environment with 

sufficient lighting.   

„

  Always disconnect the computer from power outlet before 

operation. 

„

  Before you take the motherboard out from anti-static bag, 

ground yourself properly by touching any safely grounded 
appliance, or use grounded wrist strap to remove the static 
charge. 

„

  Avoid touching the components on motherboard or the rear 

side of the board unless necessary. Hold the board on the 
edge, do not try to bend or flex the board. 

„

  Do not leave any unfastened small parts inside the case 

after installation. Loose parts will cause short circuits which 
may damage the equipment. 

„

  Keep the computer from dangerous area, such as heat 

source, humid air and water. 

„

  The operating temperatures of the computer should be 0 to 

45 degrees Celsius. 

„

  To avoid injury, be careful of: 

Sharp pins on headers and connectors 
Rough edges and sharp corners on the chassis 
Damage to wires that could cause a short circuit 

 

1.2 Package 

Checklist 

;

  Serial ATA Cable x2 

;

  Rear I/O Panel for ATX Case x1 

;

  Installation Guide x1 

;

  Fully Setup Driver DVD x1 

Note: The package contents may be different due to the sales region or models in which it was 
sold. For more information about the standard package in your region, please contact your dealer 
or sales representative. 
 

0.479678s