BENDIX AD-IS User's Manual | Page 7

BENDIX Dryer User's Manual - AD-IS.
Download
Page  of 16
4.8, 2327 votes
background image

7

be designed specifically for such applications and
systems.

9.

Components with stripped threads or damaged
parts should be replaced rather than repaired.  Do
not attempt repairs requiring machining or welding
unless specifically stated and approved by the
vehicle and component manufacturer.

10. Prior to returning the vehicle to service, make

certain all components and systems are restored
to their proper operating condition.

11. For vehicles with Antilock Traction Control (ATC),

the ATC function must be disabled (ATC indicator
lamp should be ON) prior to performing any vehicle
maintenance where one or more wheels on a
drive axle are lifted off the ground and moving.

GENERAL

When rebuilding or replacing components of the air dryer
and reservoir system use only genuine Bendix parts.  For
ease in servicing, the AD-IS® air dryer and reservoir system
has been designed so that any of the following maintenance
kits can be installed without removing the air dryer and
reservoir system from the vehicle.  CAUTION:  Always
depressurize the air dryer and reservoir system purge
reservoir, and all other reservoirs on the vehicle to 0 p.s.i.
before servicing the air dryer and reservoir system.

3.

Do not attempt to install, remove, disassemble or
assemble a component until you have read and
thoroughly understand the recommended
procedures.  Use only the proper tools and observe
all precautions pertaining to use of those tools.

4.

If the work is being performed on the vehicle’s air
brake system, or any auxiliary pressurized air
systems, make certain to drain the air pressure
from all reservoirs before beginning ANY work on
the vehicle.  If the vehicle is equipped with an
AD-IS® air dryer system or a dryer reservoir
module, be sure to drain the purge reservoir.

5.

Following the vehicle manufacturer’s
recommended procedures, deactivate the
electrical system in a manner that safely removes
all electrical power from the vehicle.

6.

Never exceed manufacturer’s recommended
pressures.

7.

Never connect or disconnect a hose or line
containing pressure; it may whip. Never remove a
component or plug unless you are certain all
system pressure has been depleted.

8.

Use only genuine Bendix® replacement parts,
components and kits. Replacement hardware,
tubing, hose, fittings, etc. must be of equivalent
size, type and strength as original equipment and

FIGURE 6 - SPLASH SHIELD BRACKET AND COVER - (EXPLODED VIEW)

SPLASH

SHIELD

BRACKET

SPLASH

SHIELD
COVER

LOCK TABS

 

Also See for BENDIX AD-IS

0.543649s