Avaya Bogen Automated Paging System APS 120, APS360 Setup Guide

Avaya Automated Paging System Setup Guide - Bogen Automated Paging System APS 120, APS360.
Download
Page  of 4
4.6, 1088 votes
background image

03/09/99

APS 120/360 Setup Guide

The following instructions should help you in setting up the equipment and in demonstrating the
capabilities of the APS120 or APS360 unit.

The package should contain the following equipment

●  

One APS120 or APS360 Controller Unit

●  

One 9 VAC Power Supply for APS120 or APS360

● 

Two standard RJ-11 telephone cables

● 

One APSXMTR unit

●  

One APSXMTR Power supply and data harness

●  

One APSXMTR 400MHz1/2 wave Antenna and right angle BNC connector.

Setup of the equipment is as follows:

Step 1: Unpack and verify that all of the above items are present.

Step 2: Place the APS120 or APS360 Controller Unit in the desired location. The unit may be either
wall mounted or placed in some other secure location.

Step 3: Connect the APS 9VAC power supply to the unit via the labeled barrel jack connection. The
barrel jack is located on the bottom right hand comer of the unit.

Step 4: Connect the APS 9VAC power supply to a standard 110V AC outlet. The RED Power LED on
the front of the unit should be lit. It is normal for the GREEN In Use and Program LEDs to light briefly

upon power up. They should return to the unlit condition after a few seconds.

Step 5: Place the APSXMTR unit in the desired location. The unit may be either wall mounted or
placed in some other secure location.

Step 6: Connect the APSXMTR Antenna to the BNC connector located on the top of the APSXMTR
unit. You may or may not employ the right angle connector. IMPORTANT: NEVER OPERATE THE
APS120 UNIT WITHOUT HAVING THE APSXMTR ANTENNA CONNECTED. DAMAGE TO THE
APSXMTR MAY RESULT!

Step 7: Connect the APSXMTR Power supply and data harness to the APSXMTR. The harness is
labeled at each end to ensure proper connection. The APSXMTR has two connectors located on the
top of the unit. The APS XMTR harness connects to the 9 pin female serial connector. The harness is
shaped like a ‘Y’ cable with the power supply at one end of the ‘Y’ and the Transmitter at the other end.

Step 8: Connect the other 9 pin female connector to the TRANSMITTER port on the bottom of the
APS120 Controller unit. This connector is labeled “Connects to Computer”. This connector is located at
the center of the ‘Y’ cable.

1

Related Manuals for Avaya Bogen Automated Paging System APS 120, APS360

0.560372s