Ariston LFC2C19/X AUS Operating Instructions | Page 8

Ariston Dishwasher Operating Instructions - LFC2C19/X AUS.
Download
Page  of 8
4.7, 1677 votes
background image

8

TROUBLESHOOTING

MAINTENANCE AND TROUBLESHOOTING GUIDE
For more information, maintenance procedures and troubleshooting,
see the Use and Care Guide
The Use and Care Guide can be obtained by:
• After-Sales Service; phone number see in warranty booklet.
• download from website: www.aristonbrand.com
• use QR code

CONTACTING AFTER-SALES SERVICE
When you contact the After-Sales Service, 
you must provide the codes shown on 
the rating plate attached to the left or 
right side inside the door of the 
dishwasher. The phone number is listed 
in the warranty booklet.

Your dishwasher may not work properly. 

Before contacting the Service Centre check if the problem can be solved by going through the following list. 

PROBLEMS

POSSIBLE CAUSES

SOLUTIONS

The dishwasher 
won’t start or does 
not respond to 
commands.

The appliance has not been plugged in 
properly. 

Insert the plug into the socket.

Power outage.

The dishwasher starts automatically when the power returns.

The dishwasher door is not closed.

Vigorously push the door until you hear the “click”.

It does not respond to commands.

Switch off the appliance by pressing the ON/OFF button, switch it back on 
after approximately one minute and reset the program.

The dishwasher 
won’t drain.

The wash cycle has not finished yet.

Wait until the wash cycle finishes.

The drain hose is bent.

Check that the drain hose is not bent (see INSTALATION INSTRUCTION).

The sink drain pipe is blocked.

Clean the sink drain pipe.

The filter is clogged up with food residues

Clean the filter (see CLEANING THE FILTER ASSEMBLY).

The dishwasher 
makes excessive 
noise.

The dishes are rattling against each.

Arrange the crockery correctly (see LOADING THE RACKS).

An excessive amount of foam has been 
produced.

The detergent has not been measured out correctly or it is not suitable for 
use in dishwashers (see FILLING THE DETERGENT DISPENSER). Reset dish-
washer by pressing the DRAIN button (see OPTIONS AND FUNCTIONS) and 
run new program without detergent.

The dishes are not 
clean.

The crockery has not been arranged 
properly.

Arrange the crockery correctly (see LOADING THE RACKS).

The spray arms cannot rotate freely, 
being hindered by the dishes.

Arrange the crockery correctly (see LOADING THE RACKS).

The wash cycle is too gentle.

Select an appropriate wash cycle (see PROGRAMS TABLE).

An excessive amount of foam has been 
produced.

The detergent has not been measured out correctly or it is not suitable for 
use in dishwashers (see FILLING THE DETERGENT DISPENSER).

The cap on the rinse aid compartment 
has not been shut correctly.

Make sure the cap of the rinse aid dispenser is closed.

The filter is soiled or clogged.

Clean the filter assembly (see CARE AND MAINTENANCE).

There is no salt.

Fill the salt reservoir (see FILLING THE SALT RESERVOIR).

IEC 436

:

400011212982

12/2017 as - Xerox Fabriano

0.584347s