Ariston FA2 844 P IX A AUS Reference Guide | Page 7

Ariston Ovens Reference Guide - FA2 844 P IX A AUS.
Download
Page  of 8
4.6, 1596 votes
background image

EN

7

EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth. 
If they are very dirty, add a few drops of pH-neutral 
detergent. Finish off with a dry cloth. 
• Do not use corrosive or abrasive detergents. If any of 
these products inadvertently comes into contact with 
the surfaces of the appliance, clean immediately with 
a damp microfibre cloth.

INTERIOR SURFACES
• After every use, leave the oven to cool and then 
clean it, preferably while it is still warm, to remove 
any deposits or stains caused by food residues. To 
dry any condensation that has formed as a result of 
cooking foods with a high water content, leave the 
oven to cool completely and then wipe it with a cloth 
or sponge.

• If there is stubborn dirt on the interior surfaces, we 
recommend running the automatic cleaning function 
for optimal cleaning results.
• Clean the glass in the door with a suitable liquid 
detergent.
• The door can be easily removed and refitted to 
facilitate cleaning of the glasses.

ACCESSORIES
Soak the accessories in a washing-up liquid solution 
after use, handling them with oven gloves if they 
are still hot. Food residues can be removed using a 
washing-up brush or a sponge.

Do not use steam cleaning 
equipment.

Use protective gloves during all 
operations.

Carry out the required 
operations with the oven cold.

Disconnect the appliance from 
the power supply.

Do not use wire wool, abrasive 
scourers or abrasive/corrosive 
cleaning agents, as these could 
damage the surfaces of the 
appliance.

REMOVING AND REFITTING THE DOOR
1.
 To remove the door, open it fully and lower the 
catches until they are in the unlock position.

2. Close the door as much as you can. 
Take a firm hold of the door with both hands – do not 
hold it by the handle.
Simply remove the door by continuing to close it 
while pulling it upwards (a) at the same time until it is 
released from its seating (b).

~60°

a

b

~15°

Put the door to one side, resting it on a soft surface.
3.

 Refit the door by moving it towards the oven, 

aligning the hooks of the hinges with their seating 
and securing the upper part onto its seating.
4. Lower the door and then open it fully.
Lower the catches into their original position: Make 
sure that you lower them down completely.
5. Try closing the door and check to make sure that it 
lines up with the control panel. If it does not, repeat 
the steps above.

CLICK & CLEAN - CLEANING THE GLASS
1.
 After removing the door and resting it on a soft 
surface with the handle downwards, simultaneously 
press the two retaining clips and remove the upper 
edge of the door by pulling it towards you.

2. Lift and firmly hold the inner glass with both 
hands, remove it and place it on a soft surface before 
cleaning it.
3. Refit the intermediate pane (marked with “1R”) 
before refitting the inside pane: To position the panes 
of glass correctly, make sure that the “R” mark can be 
seen in the left-hand corner. First insert the long side 
of the glass indicated by “R” into the support seats, 
then lower it into position. 
Repeat this procedure for both panes of glass.

4. Refit the upper edge: A click will indicate correct 
positioning. Make sure the seal is secure before 
refitting the door.

MAINTENANCE AND  
CLEANING

Download the Use and Care Guide from  

www. aristonchannel. com for more information 

WWW

0.615644s