Ariston A64IMCA 1(X) AUS Operating Instructions | Page 3

Ariston Cookers Operating Instructions - A64IMCA 1(X) AUS.
Download
Page  of 20
4.1, 1809 votes
background image

GB

3

! Please keep this instruction booklet in a safe place for 
future reference.. Make sure the booklet remains with 
the appliance if it is sold, given away or moved.

! Please read this manual carefully: it contains 
important information on installation, operation and 
safety.

! The appliance must be installed by a qualified 
professional in accordance with the instructions 
provided. 

! Any necessary adjustment or maintenance must be 
performed after the cooker has been disconnected 
from the electricity supply.

Positioning and levelling

! The appliance may be installed alongside any 
cupboards whose height does not exceed that of the 
hob surface. 

! Make sure that the wall which is in contact with the 
back of the appliance is made from a non-flammable, 
heat-resistant material (T 90°C). 

To install the appliance correctly:
•  Place it in the kitchen, the dining room or the studio 

flat (not in the bathroom). 

•  If the top of the hob is higher than the cupboards, 

the appliance must be installed at least 600 mm away 
from them.

•  If the cooker is installed underneath a wall cabinet, 

there must be a minimum distance of 420 mm 
between this cabinet and the top of the hob. 

This distance should be 
increased to 700 mm 
if the wall cabinets are 
flammable (see figure). 
•  Do not position 
blinds behind the cooker 
or less than 200 mm 
away from its sides.

•  Any hoods must be 
installed in accordance 

with the instructions listed in the relevant operating 
manual. 

Levelling

If it is necessary to level the 
appliance, screw the adjustable 
feet into the positions provided 
on each corner of the base of 
the cooker (see figure).

The legs* fit into the slots on the 
underside of the base of the 
cooker.

Electrical connection

Mounting a Power Supply Cable

Opening the terminal board:
• 

Using a screwdriver, prise on the side tabs of 

the terminal board cover;
• 

Pull open the cover of the terminal board.

N

L

To install the cable, proceed as follows:
• 

Remove the wire clamp screw and the three 

contact screws L-N-
• 

Fasten the wires beneath the heads of the 

screws using the following color scheme : Blue (N) 
Brown (L) Yellow-Green 
• 

Fasten the supply cable in place with the 

clamp and close the cover of the terminal board.

Electrical  connection

Ovens with a three-pole power supply cable are desi-
gned to operate with alternated current at the supply 
frequency and voltage indicated on the data plate (at 
the bottom of the oven dashboard). The earthing con-
ductor of the cable is the yellow-green conductor.
Connecting the power supply cable to the mains.

Fit a normalized plug to the cable, which corresponds 
to the load indicated on the data plate; if the cooker is 
connected directly to the mains, an omnipolar circuit

Installation

HOOD

420

Min.

min. 

650

 mm. with hood

min. 

700

 mm. without hood

mm.

600

Min.

mm.

420

Min.

mm.

0.597892s