Arctic King WINDOW/WALL TYPE ROOM AIR CONDITIONER User's Manual | Page 7
IMPORTANT SAFETY INSTRUCTIONS
Be sure the electrical service is adequate for the model you have
chosen. This information can be found on the serial plate, which
is located on the side of the cabinet and behind the grille.
Be sure the air conditioner is properly grounded. To minimize
shock and fire hazards, proper grounding is important. The power
cord is equipped with a three-prong grounding plug for protection
against shock hazards.
Your air conditioner must be used in a properly grounded wall
receptacle. If the wall receptacle you intend to use is not adequately
grounded or protected by a time delay fuse or circuit breaker,
have a qualified electrician install the proper receptacle.
Ensure the receptacle is accessible after the unit installation.
Do not run air conditioner without side protective cover in place.
This could result in mechanical damage within the air conditioner.
Do not use an extension cord or an adapter plug.
For your safety
Do not store or use gasoline or other flammable vapors and liquids
in the vicinity of this or any other appliance.
Avoid fire hazard or electric shock. Do not use an extension cord or
an adaptor plug. Do not remove any prong from the power cord.
Electrical Infor mation
NOTE The power supply cord with
this air conditioner contains a current
detection device designed to reduce
the risk of fire.
Please refer to the section Operation
of Current Device for details.
In the event that the power supply
cord is damaged, it can not be
repaired.It must be replaced with a
cord from the Product Manufacturer.
Do not, under any
remove, or bypass
the grounding prong.
Power supply cord
with 3-prong grounding plug
and current detection device
Operation of Cur rent Device
The power supply cord contains a current device that senses damage to the power cord. To test your power
supply cord as follows:
1. Plug in the Air Conditioner.
2. The power supply cord will have TWO buttons on the plug head. Press the TEST button, you will notice a
click as the RESET button pops out.
3. Press the RESET button, again you will notice a click as the button engages.
4. The power supply cord is now supplying electricity to the unit. (On some products this it also indicated by
a light on the plug head.)
Do not use this device to turn the unit on or off.
Always make sure the RESET button is pushed in for correct operation.
The power supply must be replaced if it fails reset when either the TEST button is pushed, or it can not be
reset. A new one can be obtained from the product manufacturer.
If power supply cord is damaged, it can not be repaired. It MUST be replaced by one
obtained from the
Related Manuals for Arctic King WINDOW/WALL TYPE ROOM AIR CONDITIONER
Carrier Air Conditioners 24ABB3 Owner's Manual
Vicks Air Conditioners V1200 Owner's Manual
Trane Air Conditioners XL15i Owner's Manual
Oreck Air Conditioners AIR12GU Owner's Manual
Hunter Air Conditioners 30200 Owner's Manual
Heat Controller Air Conditioners InverterFlex Series Owner's Manual
Heat Controller Air Conditioners Patriot 80 Series Owner's Manual
De'Longhi Air Conditioners PAC A110 Owner's Manual
Trane Air Conditioners XE1000 Owner's Manual
Mitsubishi Air Conditioners R410A User's Manual
Sharp Air Conditioners CV10NH - 10,000 BTU Portable Air Conditioner Installation Manual
White Rodgers Air Conditioners 1F78 User's Manual
Goldstar Air Conditioners GWHD5000 Owner's Manual
Duracraft Air Conditioners AMD-8500E User's Manual
Trane Air Conditioners RTAC 140-400 User's Manual
Haier Air Conditioners Commercial Cool CPN10XCJ User's Manual
Haier Air Conditioners HSU-09HV03/R2(SDB) User's Manual
Carrier Air Conditioners 30GB User's Manual
De'Longhi Air Conditioners pinguino pac ct90 User's Manual
Comfort-Aire Air Conditioners Air Conditioner PAD-121 User's Manual
Kul Air Conditioners KU32085 User's Manual
Danby Air Conditioners DPA140HB1WDD User's Manual
Trane Air Conditioners XR14 User's Manual
Frigidaire Air Conditioners FFRH0822R1 Installation Instructions