APC RBC28 User's Manual
990-0374A revision 2 11/01
This addendum does not apply to Back-UPS Pro 1000/1400 and Smart-UPS V/S 1000/1400
I.
Installation
Follow the installation illustration on the accompanying sheet.
Note: Small sparks at the battery connectors are normal during connection.
II.
Post-Installation
Once installed,
allow the unit to charge for five hours. If the unit is an XL model, allow it to charge for
24 hours.
Note: The Smart-UPS will charge whether it is on or off, and will charge whether there is a load
present or not. In situations where the power quality is poor, it is recommended that the unit be
shutdown during this charging period. A Smart-UPS that is powered on may switch to battery
operation which would prolong the time needed to fully recharge the battery.
III. Clearing the Replace Battery LED
A.
In order for the replace battery LED to be cleared, it is necessary to run a valid self test. For a self test
to be considered valid, the following conditions must be satisfied:
■ battery capacity must be greater than 75%(minimum of four battery bar graph LEDs illuminated)
or
■ Smart-UPS must have been charging for at least 8 hours from the last low battery condition. (Low
battery condition refers to a state when the Smart-UPS battery has fully discharged).
B.
Ways to initiate a self test
A self test can be initiated in any one of five ways:
■ Start up of the UPS
■ Smart-UPS front panel test button
■ Powerchute PLUS software
■ SmartSlot Accessory
■ Automatic timer- every two weeks from turn on (see APC owners manuals for details)
IV. Verifying Operation
A.
What happens during a self test?
When a self test is initiated, the unit supports the load while operating on battery for approximately
8-10 seconds. During this period, the Smart-UPS determines the health of the battery.
B.
When should the self test be performed?
After the unit has charged for five hours, a self test can be performed.
Replacement Battery Cartridge(RBC) Addendum
RBC5, RBC6, RBC7, RBC8, RBC9, RBC11, RBC12, RBC22, RBC23, RBC24, RBC25,
RBC27, RBC28, RBC5I, RBC6I, RBC7I, RBC8I, RBC9I, RBC11I, RBC12I, RBC22I,
RBC23I, RBC24I, RBC25I, RBC5J, RBC6J, RBC7J, RBC8J, RBC11J, RBC12J,
RBC20J, RBC24J
Related Manuals for APC RBC28
-
DieHard Battery Charger 200.71222 Owner's Manual
12 pages
-
Duracell Battery Charger CEF14NC Specification Sheet
1 pages
-
ULTIMATE SPEED Battery Charger ULG 3.8 A1 BATTERY CHARGER Operation Manual
48 pages
-
Kompernass Battery Charger KH 967 Operating Manual
10 pages
-
Hoover Battery Charger Hoover Battery Chargers User's Manual
2 pages
-
Sony Battery Charger BC-TRX User's Manual
2 pages
-
Sanyo Battery Charger Battery Charger NC-MQN04E User's Manual
2 pages
-
Universal Power Group Battery Charger 24BC5000TF-1 User's Manual
1 pages
-
APC Battery Charger Back UPS BR1000G User's Manual
8 pages
-
APC Battery Charger Back UPS BR700G User's Manual
8 pages
-
APC Battery Charger Back UPS ES 450 User's Manual
6 pages
-
APC Battery Charger Back UPS RS 1200 User's Manual
2 pages
-
APC Battery Charger Back UPS RS 1500 User's Manual
2 pages
-
APC Battery Charger Back UPS XS 1000 User's Manual
1 pages
-
APC Battery Charger Back UPS XS 1500 User's Manual
2 pages
-
APC Battery Charger Back UPS XS 1200 User's Manual
2 pages
-
APC Battery Charger BE750G User's Manual
8 pages
-
APC Battery Charger XS 900 User's Manual
2 pages
-
Xantrex Battery Charger DR2424 User's Manual
122 pages
-
WORX Tools Battery Charger Charger WA3733 User's Manual
1 pages
-
Anton/Bauer Battery Charger INTERACTIVE 2000 2700 User's Manual
16 pages
-
Energizer Battery Charger Energizer Battery Charger CHVCM3 User's Manual
1 pages
-
Eveready Battery Charger Eveready Battery Charger EV2PC2 User's Manual
1 pages
-
Intermatic Battery Charger ET70115C User Manual
20 pages