Actiontec WCB3000N Quick Start Manual

Actiontec Wireless Quick Start Manual - WCB3000N.
Download
Page  of 2
4.1, 2304 votes
background image

READ FIRST! Find the Coaxial Outlet near your Router/
Gateway. If there is already a coaxial cable plugged into the 
outlet, connect the ECB2500C MoCA Network Adapter as displayed
in Figure A. If there is NOT, follow the diagram in Figure B.

Step

Place the WCB3000N Wireless Network Extender in an

area where your Wi-Fi signal is spotty (where Internet signal does
not reach or drops). You will need a Coaxial Outlet nearby.

Step

Connect the Coaxial Cable(s) to the Coaxial Outlet as shown

in either Figure A or B. Make sure you are using the appropriate
diagram for your home. See the Read First instructions above.

Step

Find the Coaxial Outlet near the Wireless Network

Extender. If there is already a coaxial cable plugged into the outlet,
connect the WCB3000N as displayed in Figure C. If there is NOT, 

follow the diagram in Figure D.

Step

Plug one end of the Yellow Ethernet Cable into an

Ethernet Port on your Router/Gateway.  Plug the other end into
the Ethernet Port on the back of the ECB2500C.

Step

Plug one end of the Power Adapter into the Power Port

on the back of the ECB2500C and plug the other end into an
Electrical Wall Outlet.

Step

Connect the Coaxial Cable to the Coaxial Outlet as shown

in either Figure C or D. Make sure you are using the appropriate
diagram for your home as described in Step 5.

Flip this Quick Start Guide over to continue 

NEXT

Installing the Kit

Figure A

Figure B

Figure C

Figure D

Step

Plug one end of the Power Adapter into the Power Port

on the back of the WCB3000N and plug the other end into an
Electrical Wall Outlet.

WCB3000N ECB2500C_InstllGd_H_MPAV EA kit QS4.qxd  10/15/13  3:46 PM  Page 1

0.493117s