Acroprint BOSS BP125-R6 User's Manual

Acroprint Time Clock User's Manual - BOSS BP125-R6.
Download
Page  of 2
4.5, 1284 votes
background image

We  thank  you  very  much  for  purchasing  the Acroprint

“BOSS” Battery Operated with Solid State Quartz Controlled

Accuracy) Time Recorder. Many engineering and testing

hours have been spent in producing for you an extremely

accurate “State of the Art” portable (Battery Powered) Time

Recording Device.
This instruction pamphlet covers the following Acroprint

BOSS Recorder:
1.

BP125-6

A stand alone recorder for use with four (4) standard

“D” cell, 1.5 Volt DC Alkaline Batteries (batteries not

included).

2.

BP125-R6 For use with four (4) standard  Rechargeable  1.5

Volt  DC  Batteries.    Equipped  with    built-in Trickle

BATTERY  Charger.  Recorder  will  run  for  several

days after power interruption. Batteries should last

for 4 to 5 years. For use in either 110 Volt or 220

Volt AC Power systems. The desired voltage should

have  been  specified  when  recorder  was  ordered.

3.

BP-125-12 For use in Motor Vehicle with 12 Volt DC Battery or

for  use  in  Extremely  Cold  Climates  with  a

(suggested) 12 Volt DC Lead Acid Battery (battery

not included).

GENERAL INSTRUCTIONS
For instructions covering the removal of the case cover,

setting  the  recorder,  changing  the  ribbon  and  general

maintenance,  please  see  the  enclosed  General  User

Instructions Pamphlet.
The BP125-6 ACROPRINT “BOSS” Recorder
Your new Battery Powered Acroprint Recorder is designed

to operate on four (4) 1.5VDC “D” cell batteries. Any make

battery will be satisfactory; however, we recommend that

you use Alkaline Batteries, which should provide you with

several months of reliable operation.

BATTERY  POWERED  USER  INSTRUCTIONS

ACROPRINT  125  “BOSS”  TIME  CLOCKS

INSTALLING THE BATTERIES
To install the batteries, loosen and remove the Butterfly

Nuts at the top of the Assembly Frame which will enable

you to pivot the entire clock mechanism forward on the

bottom screws; thereby, allowing you to gain access to

the battery holder mounted on the inside back of the case.

The top battery should have the positive terminal on the

left, as indicated on the battery holder. The positive terminals

on the other three (3) batteries should alternate as shown

on the battery holder.
If two of the batteries are improperly installed, a red light

on the circuit board, which is mounted in the upper right

hand corner of the back case, will glow RED. (See Figure

2.) If all is well, the recorder should advance one (1) minute

within sixty (60) seconds after the batteries have been

properly installed.
WEAK BATTERY WARNING
When the batteries have discharged voltage down to a

certain point, a beeper on the circuit board will be activated.

When you hear the beeping, we recommend replacing the

batteries  within five (5) days or the recorder may begin to

lose time or stop altogether. (See Figure 2.)

FIGURE 1

Butterfly Nut

Pivot

Screw

125 Battery Powered (6V DC)

0.596920s